Related Manuals for Rheem RWMV
Summarization of Contents
SAFETY INFORMATION
General Safety Precautions
Details critical safety warnings, cautions, and notices for installation and operation.
Proposition 65 Health Disclosure
Informs about chemicals known to cause cancer or birth defects.
GENERAL INFORMATION
Air Handler Component Overview
Identifies main components of the hydronic air handler through diagrams.
Efficiency and Indoor Air Quality
Discusses how duct system and proper balance impact efficiency and indoor air quality.
LOCATION REQUIREMENTS AND CONSIDERATIONS
Site Selection and Clearances
Guides on choosing unit location and maintaining required clearances for safety and access.
SELECTION PROCEDURE
Load Calculation and Unit Selection
Outlines steps for load calculation and selecting the appropriate unit based on capacity.
HEATING PERFORMANCE AND DUCTING
Heating Performance Data
Presents heating performance data including capacity, airflow, and temperature rise.
Ducting Requirements and Guidelines
Details proper airflow requirements, duct sizing, and static pressure drop considerations.
INSTALLATION
Suspended Cabinet Installation
Describes methods for suspending the air handler cabinet using straps or rods.
PLUMBING AND PIPING
Codes, Materials, and Water Connections
Specifies plumbing codes, solder types, and water storage tank connection requirements.
Tubing Installation and Thermal Management
Guides on tubing installation, support, thermal expansion, and resistance calculations.
Equivalent Pipe Length Calculation
Details the method for calculating total equivalent pipe length using fittings and tables.
System Purging and Priming Procedure
Provides a procedure for purging and priming the hydronic system to remove air.
ELECTRICAL WIRING AND CONTROLS
Wiring Safety, Compliance, and Thermostats
Details safety, compliance, thermostat compatibility, and installation guidelines.
Low Voltage Wiring and Thermostat Setup
Covers low voltage wiring diagrams, dip switch options, and thermostat installation.
OPERATION AND START-UP PROCEDURES
Start-Up Procedures (Heating & Cooling)
Details pre-start checks and procedures for both heating and cooling system start-up.
Troubleshooting Controls and Fault Codes
Guides on diagnosing blower/pump issues and interpreting control board fault codes.
SEQUENCE OF OPERATION
Cooling and Hydronic Heating Modes
Explains cooling operation and hydronic heating modes, including pump and blower control.
Blower, Defrost, and Modulating Controls
Details blower delays, defrost, emergency heat, thermostat settings, and modulating heating operation.
Blower Speed Adjustment Procedures
Provides instructions and warnings for changing blower motor speed settings.
MAINTENANCE
Maintenance Safety and Warnings
Emphasizes safety precautions before performing any maintenance on the unit.
System Operation, Inspection, and Troubleshooting
Advises on system operation, inspection, troubleshooting, and wiring diagrams.
Need help?
Do you have a question about the RWMV and is the answer not in the manual?
Questions and answers