Related Manuals for BDI 6521
Summary of Contents for BDI 6521
- Page 1 CORRIDOR 6521 ® DESK INSTRUCTION MANUAL LET’S GET STARTED. DESIGN MATTHEW WEATHERLY...
- Page 3 Congratulations on the purchase of your Corridor Desk 6521 from BDI. Your desk has been designed to provide a lifetime of enjoyment. This manual will provide you with assembly instructions and other helpful information that will ensure that you get the most out of your product.
- Page 4 HARDWARE AND COMPONENTS Unpack and identify the parts listed below. The assembly workspace should be a non-marring surface such as carpet. For missing hardware pieces, please contact BDI Customer Service at customerservice@bdiusa.com. Do not use power tools for assembly of this product.
- Page 5 HARDWARE AND COMPONENTS HARDWARE AND COMPONENTS PART # PART # DESCRIPTION DESCRIPTION Drawer Assembly Left Leg QUANTITY QUANTITY PART # PART # DESCRIPTION DESCRIPTION Right Leg Wire Management Trough QUANTITY QUANTITY PART # PART # DESCRIPTION DESCRIPTION Glass Panel Modesty Panel QUANTITY QUANTITY PART #...
- Page 6 Repeat to attach (A2) Left Leg to Modesty Panel H5-SCREW Assembly. Install (H13) Levelers to the bottom of (A2 & A3) Legs. With the help of another person, H13-LEVELER turn desk upright onto its base. Colored 6 | BDIUSA.COM CORRIDOR 6521...
- Page 7 STEP 3. SECURE LEG ASSEMBLY ASSEMBLY Insert (H7) Barrel Nut into holes of (C10) Modesty PART/DESCRIPTION Panel with the elongated slot sitting horizontally, and secure with (H9) Screw through side of (A2 & A3) Legs. H7-BARREL NUT NOTE: Keep screws loose until Step 4. H9-SCREW Elongated slot in (H7) Barrel...
- Page 8 (H10) Screw through top of (A1) Drawer Assembly. Fully tighten all Screws that have been installed in H7-BARREL NUT previous steps using (T1) Hex Wrench. H8-SCREW H10-SCREW Elongated slot in (H7) Barrel Nut aligns with (H10) Screw 8 | BDIUSA.COM CORRIDOR 6521...
- Page 9 STEP 5. INSTALL BUMPERS & INSERT DRAWER LINERS ASSEMBLY Insert (H11) Bumpers in the center hole and outer PART/DESCRIPTION holes of (A1) Drawer Assembly. With the fabric side facing up, insert (C13) Center Drawer Liner into the H11-BUMPER center drawer and (C14) Side Drawer Liners into both side drawers.
-
Page 10: Fine Tuning
Phillips Screwdriver FINE TUNING Place AC power strip/surge protector (not included) into (A4) Wire Management Trough. To level your Corridor Desk, dial down one or more levelers with the (T2) Leveler Wrench until you attain a level stance. 10 | BDIUSA.COM... -
Page 11: Care And Maintenance
While BDI’s stained wood finishes are stable in tone & appearance, all finishes are subject to some degree of discoloration with prolonged exposure to direct sunlight. Please take care to avoid positioning your BDI cabinet in any area with extensive direct sunlight. -
Page 12: Warranty
WARRANTY BDI warrants to the original purchaser that for the below-stated warranty term, BDI will repair or replace any product, part, or component covered by this warranty that fails under normal use as a result of a defect in material or workmanship. BDI will repair or replace the aforementioned product, part or component with a comparable product, part or component.
Need help?
Do you have a question about the 6521 and is the answer not in the manual?
Questions and answers