Table of Contents
Advertisement
B-VENT FREESTANDING FIREPLACE
FREESTANDING
FIREPLACE
ASSEMBLY
Continued
INSTALLING REAR COVER
1.
Lift rear panel over vent pipe connec-
tion on firebox. Rear cover will rest on
the bottom ledge of the stove body.
2.
Using screws provided, attach rear
cover to back of stove body. See Fig-
ure 17.
IMPORTANT: This rear cover must be
securely in place before venting pipes
are installed.
Figure 17 - Installing Rear Cover
®
VENTING
INSTALLATION
WARNING: Read all instruc-
tions completely and thoroughly
before attempting installation.
Failure to do so could result in
serious injury, property damage,
or loss of life. Operation of im-
properly installed and maintained
venting system could result in
serious injury, property damage,
or loss of life.
NOTICE: Failure to follow these
instructions will void the warranty.
Rear
Cover
Firebox
Installed In Cast
Iron Stove Body
INSTALLATION PRECAUTIONS
Consult local building codes before begin-
ning the installation. Only a qualified ser-
vice person should install venting system.
The installer must follow these safety rules:
• Wear gloves and safety glasses for pro-
• Use extreme caution when using ladders
• Be aware of electrical wiring locations
The following actions will void the war-
ranty on your venting system:
• Installation of any damaged venting
• Unauthorized modification of the vent-
• Installation of any component part not
• Installation other than as instructed by
Your fireplace is approved for use with any
listed gas vent. A listed gas vent is a factory
made and listed system designed, and in-
stalled exclusively for removing products
of combustion, excess air, and dilution air
Screw
resulting from burning fuel gas. Metal vents,
the most common type of vent, employ
double wall construction enclosing an insu-
lating air space. This air space both helps
keep flue gases warm and reduce heat trans-
ferred to nearby combustibles. This appli-
ance is equipped with a safety control sys-
tem designed to protect against improper
venting of combustion products.
It is very important that the venting system
maintain its balance between the combus-
tion air intake and the flue gas exhaust.
Certain limitations apply to vent configura-
tions and must be strictly followed.
8
tection
or when on roof tops
in walls and ceilings
component
ing system
manufactured or approved by DESA
International
these instructions
WARNING: This gas fireplace
and vent assembly must be vented
directly to the outside. The venting
system must NEVER be attached
to a chimney serving a separate
solid fuel burning appliance.
105500
Advertisement
Table of Contents
