Learning Commands - GE 24959 Instruction Manual

Learning Commands

1. Press and hold the SETUP button until the red
indicator turns on, then release the button.
2. Press and release the desired mode button
(TV, DVD, etc.), the red indicator blinks then
stays on.
3. Press and release the LEARN button, the red
indicator blinks then stays on.
4. Press and release the Learning Remote button
that you want to teach (e.g. POWER).
5. Point both remotes facing each other by ap-
proximately 1 inch apart (see tips on page 12).
6. Press and hold the Original Remote button
(e.g. Power) until the red indicator blinks once
and stays on. If there is a learning problem, the
indicator blinks for three seconds and stays on.
If this happens, repeat Steps 4 to 6.
7. Repeat Steps 4-6 for other buttons you want to
learn.
8. Press and release the SETUP button when all
desired remote commands are learned. Code
Learning is now complete.
2.
1.
Line up your remotes (that you're learning from)
in front of the learning remote on a hard surface
approx. 1-inch apart.
dvr
sat
dvd
amp
tv
aspect
setup
no
light
page
7
8
+100
0
15
vcr
cbl
aux
learn
yes
page
9
enter
4.
3.
6.