Page 8
Contents INTRODUCTION Note to the Owner ................3 Safety rules .
Page 9
INTRODUCTION Note to the Owner General instructions Important notice All maintenance and repair operations described in this manual should be carried out exclusively by the NEW HOL- LAND authorised workshops. All instructions detailed should be carefully observed and special equipment indicated should be used if necessary.
Page 10
• Part number of the ordered part, which can be found on the “Microfiches” or the “Spare parts catalogue”, which is the base for order processing. Notes for equipment Equipment which NEW HOLLAND proposes and shows in this manual are as follows: • Studied and designed expressly for use on NEW HOLLAND tractors. • Necessary to make a reliable repair.
Page 11
INTRODUCTION Safety rules Pay attention to this symbol This warning symbol points out important messages involving personal safety. Carefully read the safety rules contained herein and follow advised precautions to avoid potential hazards and safeguard your safety and personal integrity. In this manual you will find this symbol together with the following key-words: WARNING –...
Page 12
INTRODUCTION • To transfer a failed tractor, use a trailer or a low loading platform trolley if available. • To load and unload the machine from the transportation mean, select a flat area providing a firm support to the trailer or truck wheels. Firmly tie the machine to the truck or trailer platform and block wheels as required by the forwarder.
Page 13
INTRODUCTION Engine • Always loosen the radiator cap very slowly before removing it to allow pressure in the system to dissipate. Coolant should be topped up only when the engine is stopped or idle if hot. • Do not fill up fuel tank when the engine is running, mainly if it is hot, to avoid ignition of fires in case of fuel spilling. •...
Page 14
MULTI-PURPOSE GREASE NOTICE: Use only heavy-duty, low silicate coolant such as NEW HOLLAND AMBRA ACTIFULL™ OT EXTENDED LIFE COOLANT anti-freeze. Automotive antifreeze purchased at local supply store outlets most likely is not low silicate and must not be used in heavy-duty diesel engines. Always have a minimum of 50% ethylene glycol coolant in the cooling system, adjusting the concentration based on ambient temperature, according to coolant label instructions.
Need help?
Do you have a question about the TD5.115 and is the answer not in the manual?
Questions and answers