Installation - Frigidaire FFBC46F5LS Use & Care Manual

InStALLAtIOn

This Use & Care Guide provides general operating
instructions for your model. Use the appliance only as
instructed in this Use & Care Guide. Before starting the
appliance, follow these important first steps.
Location
• Choose a place that is near a grounded electrical
outlet. Do Not use an extension cord or an adapter
plug.
• For optimal performance, it is recommended
that you install the appliance where the ambient
temperature is between 70 and 78 degrees
fahrenheit.
• Allow space around the unit for good air circulation.
Leave a 2 inch space on the back and sides of the
wine cooler for adequate circulation.
• Be sure the appliance stays in the upright position
during transport.
• Keep the appliance from any hazardous or
combustible agents.

nOtE
The exterior walls of the beverage cooler may become
quite warm as the compressor works to transfer heat
from the inside. Temperatures as much as 30° F
warmer than room temperature can be expected. For
this reason it is particularly important in hotter climates
to allow enough space for air circulation around your
appliance.
Leveling
The beverage cooler must have all bottom corners resting
firmly on solid floor. The floor must be strong enough
to support a fully loaded beverage cooler. nOtE: It is
Very Important for your appliance to be level in order to
function properly. If the appliance is not leveled during
installation, the door may be misaligned and not close
or seal properly, causing cooling, frost, or moisture
problems.
To Level Your Beverage Cooler:
After removing all interior and exterior packaging
materials, use a carpenter's level to level the beverage
cooler from front-to-back. Adjust the leveling legs in
front, ½ bubble higher, so that the door closes easily
when left halfway open.
4
Cleaning
Handle
Wooden Shelf Made of Beech
• Wash any removable parts of the beverage cooler
interior, and exterior with mild detergent and warm
Control Panel
water. Wipe dry. Do not use harsh cleaners on these
Glass Door
surfaces.
Control Switch of Lamp
• Do not use razor blades or other sharp instruments,
Adjustable Leg
which can scratch the appliance surface when
removing adhesive labels. Any glue left from the tape
Placement of Wine Cooler
can be removed with a mixture of warm water and
The wine cooler should be placed in dry and ventilated room. The location of
mild detergent, or touch the residue with the sticky
side of tape already removed. Do not remove the
the wine cooler should not be irradiated by direct sunshine. The wine cooler
serial plate.
should be far away from heating sources, such as: cooking stove or heating
Important Safeguards: Do not store food in your wine
radiator. If the wine cooler has to be placed near heating source, please adopt
cooler as interior temperature may not get cool enough
proper heating insulation board for insulation or keep the wine cooler at least
to prevent spoilage. In summer months or areas of high
the following minimum distances away from the heating sources:
humidity, the glass door may build up moisture. To
remove the moisture, wipe it away.
For electric stove: 3 .
For oil or coal stove: 30 .
Handle Installation
Replacement of Door Hinge
1. Place handle over the two mounting studs located at
The door hinges of this wine cooler can be interchanged between the left and
top of door.
right sides.
2.
Use hex head screw driver or allen wrench to tighten
Installation of Handle
set screws from bottom to secure handle to door.
1. Set the handle on the fixation shaft.
2. Screw down the fixation pins of the handle with screw driver.
Fixation Shaft of Handle
Mounting stud
Set Handle
Locate handle
Set screws
- 7 -