Operating Heater - Desa CLD3018PTA Owner's Operation And Installation Manual

INSTALLATION
Continued
4. Place crossover log (#5) onto the pin (left) on
middle log (#1) and onto the pin on front left
log (#3) (see Figure 24).
5. Place crossover log #6 onto the pin (right)
on middle log (#1) and onto the pin on back
log (#2) (see Figure 24).
6. Place crossover log (#7) onto pin on cross-
over log #6 and pin on right front log (#4)
(see Figure 25).
5. Add lava rock around base of heater if desired.
Do not place any lava rock on logs or burner.
Log #3
Grate Fingers
Figure 23 - Installing Front Logs
(#3 and #4)
Crossover
Log (#5)
Figure 24 - Installing Crossover Logs
(#5 and #6)
18
Figure 25 - Installing Crossover Log (#7)
Log #4
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must be
B. BEFORE LIGHTING smell all around the
Crossover
Log (#6)
C. Use only your hand to push in or turn the
D. Do not use this appliance if any part has
www.desatech.com
Crossover
Log (#7)

OPERATING HEATER

MANUALLY-CONTROLLED
MODELS
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
lighted by hand. When lighting the pilot,
follow these instructions exactly.
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
gas control knob. Never use tools. If the
knob will not push in or turn by hand, don't
try to repair it, call a qualified service tech-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.
been under water. Immediately call a quali-
fied service technician to inspect the
113101-01A