Operating Heater - Desa CLD3018PT Owner's Operation And Installation Manual

INSTALLATION
Continued
3. Locate the notches in the bottom of the front log (#3). Place the
front log on the grate fingers. Make sure the notches of the front
log line up with the grate fingers (see Figure 23).
4. Place crossover log (#4) onto the pin (right) on back log (#2) and
into the recess of the middle log (#1) (see Figure 24).
5. Add lava rock around base of heater if desired. Do not place
any lava rock on logs or burner.
Hole in
Grate Base
Burner
Figure 22 - Installing Back Log (#2)
Notches
Grate Fingers
Figure 23 - Installing Front Log (#3)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107068-01F
Installing Logs, Models CLD3018PA, CLD3018NA, CLD3018PT, CLD3018NT,
OPERATING HEATER Manually-Controlled Models
Back Log (#2)
Peg
Front Log (#3)
CLD3924PTA and CLD3924NTA (Cont.)
For Your Safety Read Before Lighting
Figure 24 - Installing Crossover Log (#4)

OPERATING HEATER

MANUALLY-CONTROLLED MODELS
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
INSTALLATION
15
15
Crossover
Log (#4)
Peg
Recess