Table of Contents
Advertisement
Section 1
Section 2
Section 3
Section 4
Section 5
Section 6
Section 7
Section 8
Section 9
Section 10
Section 11
Section 12
Rev. 10/19
Quick Set up Procedure
Stoplight Instructions
Wireless Instructions
Trouble Shooting
Manual Revision History
2
3
4
5
6
7
8–13
14-16
17-19
20
21
22
23
1
Advertisement
Table of Contents
Related Manuals for Matko SG
Summarization of Contents
Mounting Dimensions and Viewing
Mounting Options
Details various methods for mounting the display unit.
Roof Mount
Illustrates the roof mounting configuration for the display.
Wall Mount
Depicts the wall mounting configuration for the display unit.
Side Mount
Shows the side mounting configuration for the display.
Eave Mount
Presents the eave mounting configuration for the display.
Mounting Bracket
Explains the use and configuration of the mounting bracket.
Option Details
0: Restore Factory Defaults
Resets the display to its original factory settings.
1: Version
Displays the current software version of the unit.
2: Toledo
Configures data stream decoding for Toledo indicators.
3: Timeout Length
Sets the maximum time between data streams before interruption.
5: No Data
Defines display behavior when no data stream is received.
6: Fixed Decimal Point
Controls the illumination of decimal points in the display.
7: No Count Down
Disables the display's power-up countdown sequence.
8: No Zero Suppression
Prevents the suppression of leading zeros in the display.
10: Mirror
Enables display mirroring for rear-view mirror readability.
11: Addressable
Configures the display to respond to specific addressable characters.
12: No Auto Shift
Controls automatic shifting of displayed data.
13: Fixed Value
Sets or views the shift amount for display data.
16: Minimum Weight
Sets the minimum weight threshold for display.
17: Maximum Weight
Sets the maximum weight threshold for display.
18: Blank Out Character 1
Defines a character to blank the display upon detection.
19: Blank Out Character 2
Defines a second character to blank the display upon detection.
21: Red Stoplight
Configures the red stoplight function and behavior.
22: Green Stoplight
Configures the green stoplight function and behavior.
23: Grams / Ounces
Sets annunciator display for grams and ounces.
24: Fairbanks Addressable
Configures addressable settings for Fairbanks indicators.
25: Fixed Annunciator
Forces annunciators based on predefined values.
26: Demo Mode
Enables a demo mode for cycling through weights.
27: Intensity
Sets the LED intensity to low (OFF) or high (ON).
28: Siemens
Enables interface with Siemens Milltronics BW500 Integrator.
Stoplight Configuration
Switch Operation
Details stoplight control using a dry contact switch.
Single Line TTL Control
Explains stoplight control via single line TTL output.
Dual Line TTL (Open On)
Configures dual line TTL for stoplight control (open on).
Dual Line TTL (Closed On)
Configures dual line TTL for stoplight control (closed on).
Momentary Green Control
Describes momentary green light activation.
Momentary Red Control
Describes momentary red light activation.
ASCII Control
Utilizes ASCII characters for stoplight control.
Serial Traffic Commands
Uses specific commands for traffic light control.
Wireless System Setup
Transceiver Configuration
Guides the setup of the wireless transceiver unit.
Receiver Configuration
Guides the setup of the wireless receiver unit.
XT400 Input/Output Setup
Configures digital I/O lines for the XT400 unit.
RF Exposure Information
Provides safety guidelines regarding RF exposure.
Troubleshooting Common Issues
General Purpose Solution
Provides a general solution for communication loss.
Need help?
Do you have a question about the SG and is the answer not in the manual?
Questions and answers