Quick Installation - ViewSonic G75FB User Manual

Quick Installation

E
1 Connect video cable
N
Make sure both the monitor and computer
G
are powered OFF.
L
Connect the video cable to the computer.
I
Macintosh users: Models older than G3
S
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
H
cable into the adapter.
To order a ViewSonic
contact ViewSonic. See Customer Support
in this user guide.
2 Connect power cord
Connect the power cord from the monitor to
a properly grounded AC outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
NOTE: At this point Windows 98 users may
receive a message asking them to install the
G75f INF file.
4 Install display optimization files
(INF and ICM files)
(1) Insert the ViewSonic Wizard CD-ROM
into your computer's CD-ROM drive.
4 ViewSonic
®
Macintosh adapter,
Power
Cords
G75f
NOTE: If your computer does not have a
CD-ROM drive, see Customer Support in
this user guide.
(2) Wait for the CD-ROM to auto-start.
NOTE: If the CD-ROM does not auto-start:
double-click on the CD-ROM icon in the
Windows Explorer, then double-click on
install.exe
(3) Follow the on-screen instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh
rate)
Example: 1024 X 768 @ 75Hz.
For instructions on changing the resolution
and refresh rate, see the user guide for your
computer's graphics card.
Installation is complete. Enjoy your new
G75f monitor!
To be best prepared for any future customer
service needs:
Write the serial number (see back of the
monitor) in "For your Records" on page 2 of
this guide.
Register your product on the Internet at:
www.viewsonic.com
Video Cable