Martin Audio W8L Longbow Application Manual page 105

W8L/Longbow
Important Note:
MA4.2S power amplifier output NL4 connectors carry both
channels (e.g. pins +1/-1 = Ch1, +2/-2 = Ch2).
Always use NL2 connectors for power amplifier outputs to
avoid mispatching.
W 8 L / L o n g b o w
C o n n e c t o r C o n n e c t o r
NL8 PA-Con
+1 A
-1 B
+2 C
-2 D
+3 E
-3 F
+4 G
-4 H
Neutrik Cable and panel connector part numbers
Please note the following part numbers when ordering loudspeaker connectors
to make up NL8 cables and patch panels.
Neutrik NL8 connectors
NL8FC 8 pole cable (female)
NL8MPR 8 pole panel (male)
NL8MM 8 pole inline coupler (male- male)
Connectors should be kept in good, clean condition to ensure full, undistorted
loudspeaker performance. Worn, corroded or damaged pins and sockets can cause
severe distortion or loss of signal.
Recommended loudspeaker cable
8-core cable is required for W8L/Longbows. Although some Wavefront series
loudspeakers use less than 8 cores we recommend that rental companies standardise
on 8-cores for all NL8 or PA-Con cables to avoid confusion when using a mixture
of products in the Wavefront range.
and W8LD pin-outs and cabling
Function
W8L/Longbow
Low +
Low -
Low +
Low -
Mid +
Mid -
High +
High -
All material © 2007. Martin Audio Ltd. Subject to change without notice.