Input Setup Submenu; Crossover Sub-Menu - Martin Audio DX1 User Manual

Speaker management system

Hide thumbs Also See for DX1:

Dimensional drawing (1 page)

Table Of Contents

Table of Contents

CONTENTS

Press MENU and select crossover Sub-menu using the BACK, NEXT and

ENTER keys. Three options are available in this sub-menu which are:

Load a crossover Loads a factory preset or crossover stored in a user

memory. Note: the unit ships with all user memories empty. It is up to the

user to program these memories as the application requires. However, all

the most common settings for our products are included in the factory

presets for your convenience and in the majority of cases it will not be

necessary to use this option.

Note: loading a crossover will not overwrite the input settings.

Design a crossover Opens a utility to design a crossover. Options

include format type, ganging of outputs, routing and automatic limiter time

constants.

Store a crossover Stores a crossover (all output settings) to one of 19

user memories. Use the FREQ control to select the memory number.

Press ENTER and you will be prompted to set the memory name. Use the

FREQ control to scroll through the available characters. Use the NEXT key

to move to the next character. The memory name can contain up to 16

characters. Press ENTER to store to memory.

Note: this sequence must be completed for a memory to store. If after 15

seconds no store has been implemented the unit will return to the default

mode.

When storing a memory the LCD shows the next available empty memory

automatically but any user memory number can be chosen and any user

memory can be overwritten. Previously used memories are identified by a

'?' question mark. Note: the factory presets cannot be overwritten. If you

want to make a permanent record of the user configurable settings of a

factory preset, the preset can be saved to a user memory by following the

above procedure. This is especially useful if the unit is to be used with a

variety of presets on a regular basis. This will not unlock the 'locked'

parameters of the preset!

Note: it is not possible to save the input settings to a user memory.

Press MENU and select Input Set-up Sub-menu using the BACK, NEXT

and ENTER keys. There is one option in this menu:

Gang Inputs: Gangs A and B inputs so that precise adjustments can be

made to both inputs simultaneously. In this mode the LCD will show A+B

when either of the input 'GAIN' buttons are pressed.

CROSSOVER SUB-MENU