Remote Control; Inserting Batteries Into The Remote Control; Using The Remote Control - Arcam SOLO MINI Handbook

remote
control
Inserting batteries into the

remote control

1. Open the battery compartment by pressing the
button on the back of the remote control.
2. Insert two 'AAA' batteries into the battery
compartment, following the polarity indications
given inside the compartment itself.
3. Push the battery cover back into position.

Using the remote control

Please keep in mind the following when using the remote
control:
Ensure that there are no obstacles between the
<
remote control and the remote sensor on Solo
Mini. The remote has a range of about seven
meters.
Remote operation may become unreliable if
<
strong sunlight or fluorescent light is shining on the
remote sensor of Solo Mini.
Replace the batteries when you notice a reduction
<
in the operating range of the remote control.
E-14
General Solo Mini commands
Switches Solo between Clock mode and
2
On.
DiSP Cycles the brightness of the front-panel
display. The brightness for clock mode
may be set to a different value from the
normal power on mode.
Source Press the appropriate button to select the
selection audio source you would like to hear:
CD
, / , , , , or
Fm DaB am FROnt tV aV GamE taPE
Where DAB is fitted, press / twice
DaB am
to select AM.
Press twice to select USB.
FROnt
Adjusts the amplifier volume.
F , G
B , C The B and C keys are used to
F G
navigate the System menu, and to
F , G
adjust the settings, together with the
Ok
and
Ok
button (see pages 16).
Press once to mute the speaker and
-
pre-amp outputs of Solo Mini. Press for
a second time (or adjust the volume) to
unmute the unit.
mEnU In 'Clock mode' (red light), the
mEnU
button enters the Alarm setting menu
(see page 18). In 'Power on' mode (blue
light) enters the System menu (see
mEnU
page 16). Press the button for a
mEnU
second time to leave the menu.
,
.