Related Manuals for Epson SureColor B6000 Series
Summarization of Contents
Setting the Ink Tank
Put the CSIC Chips on the Slider
Procedure for attaching CSIC chips onto the slider for ink tank installation.
Push topside and Insert the INKHOLDER
Instructions on pushing the topside and inserting the ink holder into the printer.
Set Ink Tank with reference to Ink Supply Cover
Guidance on setting the ink tank using the ink supply cover as a reference point.
Set the Bk Ink Tank at first (Most right side)
Instruction to set the Black ink tank first on the most right side of the unit.
Set to fit between cut position of Ink Tank and hook of Ink Holder
Aligning the ink tank between its cut position and the ink holder's hook correctly.
Check the depth of Hook
Verification of the hook's depth for proper ink tank seating and engagement.
Confirming the Ink Tank position
Check the vertical position of Ink Tank
Verifying the correct vertical alignment of the ink tank within the printer.
Adjusting the Ink Tank height
Check the front and rear position of Ink Tank
Checking the horizontal positioning of the ink tank at both front and rear.
Set the white adjusting plastics one by one
Instructions for inserting white adjusting plastics to set the ink tank height accurately.
Fixing the Ink Tank
Holding down and tightening screws
Securing the ink tank by holding it down and tightening four screws.
Tighten screws on Home and Full sides
Securing the ink tank by tightening two screws on both the home and full sides.
Setting the Ink Supply cover
Attach and secure Ink Supply cover
Temporarily placing the ink supply cover on the hex bolt and tightening screws.
Fill ink into ink tank
Shake ink packs before filling
Instructions to shake all ink packs horizontally before filling the ink tanks.
Cut ink pack pour spot
Guidance on cutting the pour spot of the ink pack using scissors.
Fill ink tanks from ink packs
Procedure for filling the ink tanks using ink from the ink packs.
Firmware Update Procedure
Prepare for FW update
Pre-update instruction: Do not turn on the printer before filling all inks.
Turn on printer for FW update
Instruction to power on the printer in FW update mode after filling inks.
Update to the latest FW
Procedure to update the printer's firmware to the latest version.
Verify updated FW version
Confirming the firmware version after the update process is complete.
Ink Charge Process
Power on printer
Turning on the printer in normal mode to begin the ink charging process.
Set printer settings
Configuring printer settings such as language and calendar.
Start ink charge process
Initiating the ink charging procedure on the printer.
Reference: Check ILS sensor for ink charge issues
Access Service Man Mode
Steps to enter the service man mode using specific button combinations.
Perform Mecha Adjustment and Sensor Check
Navigating menus for mecha adjustment and sensor check procedures.
Replace the Maintenance box
Replace maintenance box
Procedure for replacing the maintenance box on both right and left printer sides.
Nozzle Check Procedure
Check nozzle pattern
Instructions to check the nozzle check pattern for any missing nozzles.
Perform nozzle cleaning
Guidance on performing cleaning (CL1, CL2, or CL3) if nozzles are missing.
Customer Ink Refill Guidance
First ink refill after initial setup
Procedure for the initial ink refill after the printer's setup is complete.
Second ink refill and after
Instructions for subsequent ink refills and ongoing printer usage.
Need help?
Do you have a question about the SureColor B6000 Series and is the answer not in the manual?
Questions and answers