Table of Contents
Advertisement
L
OWERING A VEHICLE
1) Insure that the area under the vehicle is clear of personnel and tools.
2) Raise the vehicle until both latches are free.
3) Disengage the latches by pulling down and holding the lock release lever.
4) Lower the vehicle by depressing the lowering valve handle.
5) Continue to lower the vehicle until the carriages stop against the base plate. Retract the extension
arms, and park them.
M
AINTENANCE
To avoid personal injury, permit only qualified personnel to perform maintenance on this equipment.
The following maintenance points are suggestions for a preventive maintenance program. The actual
program should be tailored to the particular installation.
1) If lift stops short of full rise or chatters, check fluid level and bleed both cylinders per Installation
Instructions.
2) Replace all Safety, Warning or Caution Labels if missing or damaged (See Installation instructions
page 3.)
D
aily
1) Keep lift components clean.
2) Check for loose or broken parts.
3) Check hydraulic system for fluid leaks.
4) Check adapters for damage or excessive wear. Replace as required with genuine Lifts parts.
5) Check the lock release activation.
W
eekly
1) Check synchronizer cables and sheaves for wear. Replace as required with genuine Lifts parts.
2) Check lock release cable adjustment per Installation Instructions.
IMPORTANT
: IF IDLER SIDE LOCK PAWL DOES NOT FULLY DISENGAGE, DAMAGE
MAY RESULT TO IDLER SIDE CARRIAGE AND OR CABLE SYNCHRONIZING SYSTEM.
3) Check synchronizer cable tension per Installation Instructions. Adjust if necessary.
M
onthly
1) Torque concrete anchor bolts to 80 ft-lbs.
2) Check overhead shutoff switch. While raising lift, operate overhead shutoff bar. Power Unit motor
should stop when bar is raised.
3) Lubricate carriage slide tracks with heavy viscous grease. (Grease all (4) corners of both columns.)
If any problems are encountered, contact your local service representative.
Advertisement
Table of Contents
