Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Master Bilt DD-66
Summary of Contents for Master Bilt DD-66
- Page 1 Deluxe Ice Cream Dipping/Display Merchandisers DD – Standard Model DD-L – Low Glass Model DD-CG – Curved Glass Model Installation & Operations Manual Master-Bilt Products 908 Highway 15 North New Albany, MS 38652 Phone: (800) 684-8988 PN 059-90000 Rev 5-30-06...
-
Page 3: Table Of Contents
General Instructions…………………………………………………………………………………………. 6 Electrical…..………………………………………………………………………………………………….. 6 Mechanical…………………………………………………………………………………………………… 7 Startup………………………………………………………………………………………………………. 7 TEMPERATURE CONTROL…….…………………………………………………………………………………...7 CLEANING INSTRUCTIONS…………………………………………………………………………………………8 Can Holder Cleaning………………………………………………………………………………………. 8 Frost Shield Cleaning……………………………….………………………………………………………. 8 OPERATION CONDITIONS AND PRESSURES ……..……………………………………………………….. Trouble Shooting………………………………………………………………………………………….…9 SERVICE INSTRUCTIONS………………………………………………………………………………………….. 9 MASTER-BILT PART NUMBERS………………………………………………………………………………….. 10 ACCESSORIES………………………………………………………………………………………………………...11 SALE AND DISPOSAL………………………………………………………………………………………………. 11 WIRING DIAGRAMS…………………….………………………………………………………………………...12-14... -
Page 4: Introduction
The Master-Bilt DD should not be positioned where it is directly exposed to rays of sun or near a direct source of radiant heat or airflow. This will adversely affect the case and will result in poor performance. -
Page 5: Warning Labels And Safety Instructions
This is important installation, operation or service information. If you ignore the message, you may damage your cabinet. The warning and safety labels shown throughout this manual are placed on your Master-Bilt Products cabinet at the factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call your customer service department at (800) 684-8988 for replacements. -
Page 6: Pre-Installation Instructions
If moisture or liquid is observed around or under a Master-Bilt cabinet, an immediate investigation should be made by qualified personnel to determine the source of the moisture or liquid. The investigation should determine if the cabinet is malfunctioning or if there is a drainpipe leaking. -
Page 7: Mechanical
Remove grille and check refrigeration lines to see that they are free (not touching each other or compressor). Spin condenser fan blade to see that it is free. Check that all service valves are open.The picture below is Master-Bilt’s standard DD-Unit. The compressor is hermetic, it is internally spring mounted and ready to run. -
Page 8: Cleaning Instructions
CLEANING WARNING: DO NOT REMOVE FROST WITH A KNIFE, PICK, OR SHARP OBJECTS. DO NOT USE ABRASIVE CLEANERS OR CAUSTIC CLEANERS OR SCOURING PADS Every 30 to 60 days (depending on frost accumulation), the cabinet should be emptied, warmed up, and wiped down using a solution of 1 teaspoon of baking soda with 1 quart of water. -
Page 9: Operation Conditions And Pressures
Thermostat set too warm. Special service situations If moisture or liquid is observed around or under a Master-Bilt cabinet, an immediate investigation should be made by qualified personnel to determine the source of moisture or liquid. The investigation made should determine if the cabinet is malfunctioning or if there is a simple housekeeping problem. -
Page 10: Master-Bilt Part Numbers
MASTER-BILT PART NUMBERS The table below gives Master-Bilt part numbers. Use this chart when ordering replacement parts for your DD Standard, Low Glass and Curved Glass Models. Description DD-26(CG)(-L) DD-46(CG)(-L) DD-66(CG)(-L) DD-88(CG)(-L) Ballast, 18” 23-01709 23-01709 23-01709 23-01709 Ballast, 36”... -
Page 11: Accessories
OWNER RESPONSIBILITY If you sell or give away your Master-Bilt cabinet you must make sure that all safety labels and the Installation - Service Manual are included with it. If you need replacement labels or manuals, Master-Bilt will provide them free.
Need help?
Do you have a question about the DD-66 and is the answer not in the manual?
Questions and answers