Position Menu; H-Position; V-Position; Dot Clock - Panasonic AX200U - LCD Projector - HD 720p Operating Instructions Manual

Operating instructions
Table of Contents

Advertisement

POSITION menu

Remote control
See "Navigating through the MENU" on page 27.
See "Main menu and sub-menu" on page 28.

H-POSITION

You can move the projected image horizontally for fine
adjustment.
Move left

V-POSITION

You can move the projected image vertically for fine
adjustment.
Move
down

DOT CLOCK

If you have interference patterns of the projected image,
which is sometimes referred to as moire or noise, you
can minimize it by pressing I H to adjust the clock
frequency. (Available with signals from COMPUTER IN
only)
NOTE:
• If the projecting signal's dot clock frequency is higher
than 150 MHz, the adjustment may not make a
difference.
• DOT CLOCK needs to be adjusted before adjusting the

CLOCK PHASE.

E
34 -
NGLISH
Control panel
Move
right
Move up
CLOCK PHASE
If you require further adjustment for the same reason as
the DOT CLOCK adjustment, you can fine adjust the
timing of the clock. Press I H to adjust. (Available with
signals from COMPUTER IN/COMPONENT IN only)
NOTE:
• If the projecting signal's dot clock frequency is higher
than 150 MHz, the adjustment may not make a
difference.
• Available signals from COMPONENT IN:
1 125 (1 080)/60i, 1 125 (1 080)/50i, 1 125 (1 080)/60p,
1 125 (1 080)/50p, 1 125 (1 080)/24p, 750 (720)/60p,
750 (720)/50p

ASPECT

You can switch the aspect ratio manually when needed.
Aspect ratio depend on signals
Press I H to cycle through the aspect ratio
options. The cycle pattern depends on the
connected signals.
4:3 \ 16:9 \ 14:9 \ ZOOM1 \
ZOOM2 \ JUST
VIDEO/
AUTO \ 4:3 \ 16:9 \ JUST \
S-VIDEO
ZOOM
NTSC signal
4:3 \ 16:9 \ V SCROLL
4:3 \ 16:9
COMPUTER
VGA or SVGA signals
(RGB)
Not switchable
WIDE480/600/720/768/768-2/800/
900 signals
4:3 \ 16:9
16:9 \ H - FIT \ V - FIT \ ZOOM
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
HDMI
1 125 (1 080)/24p, 750 (720)/50p and
750 (720)/60p signals
4:3 \ 16:9 \ JUST \ ZOOM
525p (480p) and 625p (576p) signals
4:3 \ 16:9 \ 14:9 \ JUST \
ZOOM1 \ ZOOM2
625i (576i), 625p (576p)
AUTO \ 4:3 \ 16:9 \ JUST \
ZOOM
COMPONENT
525i (480i), 525p (480p)
(YP
P
)
B
R
16:9 \ H - FIT \ V - FIT
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p,
750 (720)/60p signals

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-ax200u

Table of Contents