Acer S1213Hn User Manual page 37

To connect your projector to the network:
1
2
3
4
5
LAN Setting
(for S1210Hn/
6
S1213Hn/
T212DT/XS-
X13HG/
If your are not in a DHCP environment, set DHCP to "Off" and
S1310WHn/
contact your ITS administrator for information on Projector IP
S1313WHn)
Address, Subnet Mask, Default Gateway, and DNS Server.
1
2
3
4
5
To control the projector remotely:
1
2
LAN Reset
Press
(for S1210Hn/
page to the default settings.
S1213Hn/
T212DT/XS-
X13HG/
S1310WHn/
S1313WHn)
Take a RJ45 cable and connect one end to the LAN input
jack of the projector and the other end to the RJ45 port.
Enter the LAN Setting menu. The
Password" dialogue box is displayed.
Enter "Administrator Password". The next level menu
is displayed.
The factory default of "Administrator Password" is
"1234". You can change it in the Setting > Security >
Administrator Password menu.
Select LAN in this menu and press
Make sure DHCP is on, and press
press .
Re-enter the menu and note down the IP address
displayed in the row of Projector IP Address.
Press to select Projector IP Address and press
Press to move the cursor and press
enter the digits.
When you finish, press MENU to save and exit the menu.
Repeat steps 1-3 to input addresses for Subnet Mask,
Default Gateway, DNS server.
Press to highlight Apply and press
Enter the Projector IP address in the address bar of the
web browser on your computer.
The remote network operation page is displayed.You can
control the projector by using this page. For details, see
the notes following this table.
after choosing "Yes" to return all items on the Tools
27
"Enter Administrator
to select "On".
to select Apply and
.
to
.