Troubleshooting - ZENEC ZE-NC5010 User Manual

TROUBLESHOOTING

Problem
GENEREL
Unit will not power
on.
No/low audio output.
Poor sound quality or
distortion.
TFT MONITOR
No image.
Prolonged image
or improper height/
width ratio.
Cause
Radio fuse blown.
Car battery fuse blown.
Illegal operation.
Improper audio output connection. Check wiring and correct.
Volume set too low.
Speakers damaged.
Only one channel is playing.
Speaker wiring is in contact with
metal part of car.
Mute is activated.
Badly recorded disc is in use.
Speaker power rating not
compatible with unit.
Speaker is shorted.
The parking brake is not engaged
or the car is faster than 3 km/h.
CAN-Bus Interface is defective.
The "Monitor off"-function
is activated.
Improper aspect ratio setup.
Solution
Install new fuse with correct rating.
Install new fuse with correct rating.
Press the RESET button.
Increase volume level.
Replace speakers.
Check the balance and
fader adjustments.
Insulate all speaker wiring
connections or replace the
speaker cable.
Turn off the Mute function.
Use original disc.
Connect proper speakers.
Check speaker connections.
Stop vehicle in a safe place and
apply parking brake.
Replace the CAN-Bus interface.
Touch the monitor to activate
the display.
Use correct aspect ratio setting.
79
ZE-NC5010