Automatic Needle Threader - Janome MC6600P Instruction Book

z
x
2
c
v
b
1
3
4
5

Automatic needle threader

z
Raise the needle to its highest position by
pressing the up/down needle button twice.
Turn the power switch off.
Lower the presser foot.
1 Up/Down Needle Button
x
Depress the needle threader knob as far as it will
go. The hook comes out through the needle eye
from behind.
2 Needle Threader Knob
3 Hook
c
Draw the thread down around the threader guide
and under the hook.
4 Threader Guide
v
Release the threader knob slowly while holding
the thread end with your hand. A loop of the
thread is pulled up through the needle eye.
5 Loop of Thread
b
Remove the loop from the threader and pull out
the thread end from the needle eye.
NOTES:
The automatic threader works well with the threads
#50-90 and needles #11-16, including the Blue Tip
needle.
The automatic needle threader cannot be used for
threading the twin needle.
If the hook fails to pull a loop of the thread, check the
needle and its setting.
2 1