Denon AVR-2105 Operating Instructions Manual page 41

3 Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo
SURROUND
MODE
(Main unit)
To select the surround mode while
adjusting the surround parameters,
tone defeat or tone control, press
the surround mode button then
operate the selector.
4 Start playback on the selected component.
• For operating instructions, refer to the component's manual.
5 Adjust the volume.
The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –70 to 0
to 18 dB, in steps of 0.5 dB. However, when the channel
level is set as described on page 48, if the volume for any
channel is set at +0.5 dB or greater, the volume cannot be
adjusted up to 18 dB. (In this case the maximum volume
is adjusted to "18 dB — (Maximum value of channel
level)".)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS".
SELECT
(Remote control unit)
SURROUND
MODE
(Main unit)
MASTER VOLUME
(Main unit) (Remote control unit)
Input mode display
• In the AUTO mode
INPUT
AUTO PCM DTS
• In the DIGITAL PCM mode
INPUT
AUTO PCM DTS
• In the DIGITAL DTS mode
INPUT
AUTO PCM DTS
• In the ANALOG mode
INPUT
AUTO PCM DTS
Input signal display
• DOLBY DIGITAL
SIGNAL
DIGITAL
• DTS
SIGNAL
DIGITAL
• PCM
SIGNAL
DIGITAL
The DIGITAL indicator lights when digital signals are being input
DIGITAL
properly. If the indicator does not light, check whether
the digital input component setup (page 29) and connections are
correct and whether the component's power is turned on.
NOTE:
• The DIGITAL indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
ENGLISH
One of these lights, depending on the
input signal.
DIGITAL ANALOG
DIGITAL
DIGITAL
ANALOG
41