Advertisement
3.
Secure enclosure to the desired location (indoor installation only).
4.
Disconnect power to the branch circuit to which the product will be connected.
5.
Place SW1 switch in the OFF position.
6.
Connect incoming AC power (115 V, 60 Hz):
– Hot (black) to terminal marked "L".
– Neutral (White) to terminal marked "N".
– Ground to terminal marked "G".
7.
Use the knockout in bottom of cabinet for 115 VAC wiring. Route the 115 VAC wiring at least 3/8" (0.953 cm) from
24 VAC (low voltage) wiring.
8.
Keep a ¼" (0.635 cm) separation between power limited wiring (output circuits on HPTV2404CB) and non-power
limited wiring. Use separate knockouts for power limited wiring.
9.
Connect CCTV cameras (or other external loads) to appropriate terminals: Connect circuit #1 to terminals marked
"1+" and "–". Connect circuit #2 to terminals marked "2+" and "–". Continue to connect the remaining circuits
carefully observing polarity. Terminals marked with "–" are of the same polarity.
10. Power the branch circuit and slide SW1 to the ON position. All five green LEDs should illuminate.
11. Upon completion of wiring, secure cabinet door with screws supplied, to prevent access by unauthorized personnel.
WARNING:
!
• To reduce risk of electric shock, do not expose unit to rain or excessive moisture, and disconnect
power before servicing unit.
For continuous protection against hazard, replace fuses only with exact type and rating.
• A readily accessible switched circuit breaker must be available to disconnect mains power as required.
• All 120 V wiring should be routed so that it cannot touch 24 V wiring; minimum spacing 3/8" (0.953 cm).
• Installation & servicing should only be made by qualified personnel; contains no user-serviceable parts.
• Install in accordance with all local regulations and the National Electrical Code.
NOTE: For additional information
• Visit our website: http://www.honeywellpower.com
• Contact Technical Support: (800) 627-3473
• Email us: hpp_techserv@fla-whq.com
2
HPTV2404(CB) Installation Instructions P/N 52404:A 01/17/2005
Advertisement
