Cleaning Fuel Strainer - Honeywell HW2000i - Portable Inverter Generator Owner's Manual

Cleaning Fuel Strainer

Cleaning Fuel Strainer
Gasoline containing more than 10%
Ethanol ethanol by volume may cause start-
(ethyl or grain ing or performance problems. Gaso-
alcohol) line containing ethanol may be
marketed under the name "Gasohol".
Gasoline containing methanol must
contain co-solvents and corrosion
inhibitors to protect fuel system. Gas-
Methanol
oline containing more than 5% meth-
(methyl or wood
anol by volume may cause starting
alcohol)
and/or performance problems and
may damage metal, rubber and plas-
tic parts of fuel system.
MTBE
You can use gasoline containing up
(methyl tertiary
to 15% MTBE by volume.
butyl ether)
TABLE 6. Oxygenated Fuel Types
Adding Fuel
NOTICE
To avoid damage to engine, never use stale or contaminated
gasoline or oil/gasoline mixture. Avoid getting dirt or water in
fuel tank.
Use fresh gasoline with a pump octane rating of 87 or
higher.
1. Stop the generator if the engine is running. Allow to
completely cool.
2. Place the generator on a flat, level surface.
Remove the fuel cap.
3.
FIGURE 29: Adding Fuel (HW2000i model illustrated)
Slowly pour gasoline into the fuel tank. Be careful not
4.
to overfill.
FIGURE 30: Fuel Level
22 www.honeywellgenerators.com
Reinstall the fuel cap and fully tighten.
5.
NOTE:
Occasional, light spark knock, "pinging", or rattling noise
is normal while operating under heavy loads. If spark
knock, pinging, or rattling occurs at a steady engine
speed, under normal load, drain the fuel (page 26) and
refill with fresh gasoline. If the noise persists, see an
authorized generator dealer.
NOTICE
Running the engine with persistent spark knock or pinging
can cause engine damage. Warranty does not cover parts
damaged by misuse.
Cleaning Fuel Strainer
The fuel strainer helps prevent residue from entering the
carburetor. Clean the fuel strainer at the intervals specified
in Table 3.
To clean fuel strainer, you will need:
‰ Household soap and water
‰ Clean, dry cloth
To clean fuel strainer:
Stop the generator if the engine is running. Allow to
1.
completely cool.
Place the generator on a flat, level surface.
2.
Remove the fuel cap (A) and fuel strainer (B).
3.
FIGURE 31: Fuel Strainer Removal
Clean the fuel strainer with soap and water.
4.
5. Wipe the fuel strainer clean with a clean, dry cloth.
Gently reinstall the fuel strainer and replace the fuel
6.
cap.
HW1000i / HW2000i Inverter Generator Owner's Manual