Honeywell HW4000 - Portable Generator NOT Owner's Manual page 15

Step 2: Install Wheel Axle and Wheels
To install wheel assembly, you will need:
Socket wrench with 10 mm socket
*
Needlenose Pliers
Wheel Axle (1)
16 mm full-thread hex bolts (4)
13 mm flange serrated nuts (4)
†
Axle Bracket (1)
Wheels (2)
9/16" Washers (4)
Cotter Pins (2)
* Not included.
† Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in wheel kit hardware bag.
Install wheel axle brackets to frame using 16 mm full-
1.
thread hex bolts and 13 mm flange serrated nuts.
Install pre-attached bracket to frame first.
1A.
Install other bracket (included in hardware bag) to
1B.
frame.
FIGURE 6: Wheel Axle Attached to Generator
On each end of axle:
Slide 9/16" washer onto axle.
2.
Slide and push wheel onto axle until it fits snug
3.
against washer.
FIGURE 7: Slide Wheel onto Wheel Axle
HW4000 Portable Generator Owner's Manual
4.
5.
6.
*
7.
Slide second 9/16" washer onto axle.
Slide cotter pin into pre-drilled hole until fully seated.
Using needlenose pliers, bend each end of cotter pin
in opposing directions to secure wheel to axle.
FIGURE 8: Cotter Pin Installation
Return generator in upright position (so that wheels
and leg supports are touching ground).
www.honeywellgenerators.com
Assembly
9