Hitachi 32HDT20 Operating Manual page 61

SETUP
Video 2 Auto Link
Setup
Set The Inputs
Video 1 Rename
Video 2 Rename
Video 2 Auto Link
Video 3 Rename
Video 4 Rename
Video 5 Rename
Video Power Save
Move Select
SEL
Setup
Set The Inputs
Video 2 Auto Link
Auto Input Signal Sensor
Remote Control Sensor
Off
Move Select
SEL
Use THUMB STICK or
When AUTO INPUT SIGNAL SENSOR is selected, the TV will turn on and switch to Video2 automatically, when the Video2 input device
is turned on. This is convenient when you want to watch a movie with your VCR, laserdisc player, or DVD player.
When REMOTE CONTROL SENSOR is selected, the TV will turn on and switch to Video2 automatically when the Video2 input device
is turned on (VCR, laserdisc, or DVD) and any of the buttons on your remote control is pressed.
Select Off to disable this function.
Press EXIT to quit the menu.
NOTES: 1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK is used again. To
do this, turn your VCR, laserdisc, or DVD player OFF. This feature is now reset and will turn on your TV as described
above.
2. When using REMOTE CONTROL SENSOR mode, any remote control button will substitute for your video input device
play button. However, intended operation is for use with your VCR, laserdisc, or DVD play button.
3. If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will automatically turn off after
three hours.
Use this function to automatically turn the TV on and tune to Video 2 when it detects a video signal to
input 2.
, then press down on THUMB STICK to change AUTO LINK setting.
Setup
Set The Inputs
Video 2 Auto Link
THUMB
Auto Input Signal Sensor
STICK
Remote Control Sensor
SELECT
Off
Move Return
SEL
THUMB
STICK
61