Using The Remote To Control Vcr Functions - Hitachi 32HDT20 Operating Manual

Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote command set of
your VCR. (refer to page 39 for pre-codes)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press and release the VCR button to switch to VCR pre-coded mode.
4. Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 39. The
VCR button light will flash 3 times if the code was accepted.
5. Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR if the correct two digit preset code is
entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit
preset code.
6. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the
above procedures, your VCR's code has not been
precoded into the remote.
2. In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. The MENU button will act as the VCR MENU button for
HITACHI VCRs.
5. The LAST CH button will act as your VCR ENTER button
if required.
6. The SLEEP button will act as your VCR '100' button if
required.
VCR Button
This button allows the remote to control your VCR by set-
ting it to VCR mode.
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.
For some VCRs, you must press the RECORD button twice
to record a program.
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.

USING THE REMOTE TO CONTROL VCR FUNCTIONS

TV
DVD
SLEEP
VOL
PIP MODE
MY VCR CODE IS:
34
POWER
VCR CBL
STB
SOURCE WIZARD
CD
TAPE
AMP
1
2 3
4
5 6
7
8 9
0
INFO
A/V NET
SELECT
CH
VID 3
PIP PIP CH FREEZE
PIP ACCESS
SWAP
VIDEO
REC
CLU-5723TSI