Lennox Merit Plus MPD40RNM Installation Instructions Manual
Lennox Merit Plus MPD40RNM Installation Instructions Manual

Lennox Merit Plus MPD40RNM Installation Instructions Manual

Merit plus series mpd direct-vent gas fireplaces

Advertisement

P/N 506015-07 Rev. NC 05/2012
This manual is one of a set of two supporting this product.
Refer to P/N 506017-06 for Care and Operation Instructions.
Ce manuel est disponible en francais, simplement
en faire la demande. Numéro de la pièce 506223-43.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
INSTALLATEUR : Laissez cette notice avec l'appareil.
CONSOMMATEUR : Conservez cette notice pour
consultation ultérieure.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only) or mobile
home, where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the rating
plate. This appliance is not convertible for use with other gases, unless a certified kit is used.
WARNING / AVERTISSEMENT / AVISO
• HOT GLASS WILL CAUSE
BURNS.
• DO NOT TOUCH GLASS
UNTIL COOLED.
• NEVER ALLOW CHILDREN
TO TOUCH GLASS.
WARNING: If the information in these instructions
is not followed exactly, a fire or explosion may
result, causing property damage, personal injury,
or death.
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
- Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
INSTALLATION INSTRUC TIONS
MPD Direct-Vent
Gas Fireplaces
MODELS
MILLIVOLT:
MPDT33RNM
MPDT33RPM
MPDR33RNM
MPDR33RPM
MPD35RNM
MPD35RPM
OTL Report No. 116-F-13-4
Please read and understand these instructions
• UNE SURFACE VITRÉE CHAUDE
PEUT CAUSER DES BRÛLURES.
• LAISSER REFROIDIR LA SURFACE
VITRÉE AVANT D'Y TOUCHER.
• NE PERMETTEZ JAMAIS À UN ENFANT
DE TOUCHER LA SURFACE VITRÉE.
AVERTISSEMENT : Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire au
minimum le risque d'incindie ou d'explosion ou pour
éviter tout dommage matériel, toute blessure ou la mort.
- Ne pas entreposer ni utilizer d'essence ni d'autres vapeurs
ou liquides inflammables dans le voisinage de cet appareil
ou de tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ :
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucan interrupteur. Ne pas vous servir des
téléphones se trouvant dans le bâtiment où vous trouvez.
• Appelez immédiatement votre fournisseur de gaz depuis
un voisin. Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incindies.
- L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
MPD40RNM
MPDT33RNE
MPD40RPM
MPDR33RNE
MPD45RNM
MPD35RNE
MPD45RPM
Portland
US
before starting installation.
• EL VIDRIO CALIENTE
CAUSARÁ QUEMADURAS.
• USTED DEBE NUNCA
TOCAR EL VIDRIO CALIENTE.
• LOS NIÑOS DEBEN NUNCA
TOCAR EL VIDRIO.
ELECTRONIC:
MPD40RNE
MPD45RNE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Merit Plus MPD40RNM and is the answer not in the manual?

Questions and answers

Summarization of Contents

GENERAL INFORMATION AND SAFETY
Safety Warnings and Precautions
Key safety notices and precautions for appliance operation, including general warnings and gas leak procedures.
Codes and Standards Compliance
Installation must comply with national and local codes, including NFPA and CSA standards.
Massachusetts Installation Requirements
State-specific requirements for installation in Massachusetts, including licensing and connector length.
VENTING AND CLEARANCE REQUIREMENTS
Vent Termination Clearances
Specifies required clearances for vertical and horizontal vent terminations from building elements.
Minimum Clearances to Combustibles
Defines minimum safe distances to combustible materials for appliance and vent components.
Wall Finishes and Mantels
Guidelines for installing mantels, surrounds, and wall finishes near the appliance opening.
INSTALLATION PROCEDURES
Pre-Installation and Framing
Initial checks, preparation, and construction of the fireplace opening.
Vent System Installation
Detailed steps for connecting and installing the direct-vent piping system.
Field Wiring and Gas Connections
Instructions for connecting electrical power, optional blower kits, and the gas supply line.
Appliance Setup and Operation
Procedures for verifying appliance operation, installing logs, and performing burner adjustments.
Safety Label Application
Ensures safety instruction labels are correctly affixed to the appliance for user awareness.
ACCESSORIES AND CONVERSIONS
Installation Accessories
Catalog of available components for venting, termination, firestop spacers, and guards.
Gas Conversion Kits
Information and instructions for converting the appliance to operate on different gas types.

Table of Contents