Lexicon PCM 80 - REV 0 DUAL FX User Manual page 69

PCM 80 Dual FX User Guide
3-14
4.0 Mono>Gate>BP
This mono-in/stereo-out program has a gated reverb in series with a 24dB/octave
bandpass filter. ADJUST controls the filter center frequency.
4.1 Mono>Tunnel
A special effect stereo ambience for mono sources. ADJUST controls its overall
character. At low settings this space is open and airy, at higher settings it grows dark and
ominous.
4.2 Mono>CarPark
Puts mono sources into a large concrete parking garage. ADJUST controls overall decay
and feedback. As it is turned up to higher settings, the ambience becomes increasingly
ominous. At the highest settings, an eerie ringing rises up and rings out.
Presets 4.3-4.9 will create stereo ambience effects from mono sources. Each program
combines one of three basic reverberant spaces with a low, high, or band pass 24 dB/
octave filter. Amb1 is a highly colored room with short decay. Amb2 is more transparent
with a moderate decay. Amb3 is a tight space with prominent reflections. ADJUST
controls the filters following the ambience effect, allowing you to quickly tailor the sound
to create the impression of different wall coverings, open and closed doors, telephones,
radios, distance of the source, etc. The Soft Row contains additional parameters for fine
tuning. Stereo source versions of these effects are located in Bank X0 2.1-2.7.
4.3 Mono>Amb1>LP
Mono-in, Amb1 followed by 24dB/octave lowpass filter. ADJUST controls high frequency
cutoff.
4.4 Mono>Amb1>HP
Mono-in, Amb1 followed by 24dB/octave highpass filter. ADJUST controls low frequency
cutoff.
4.5 Mono>Amb1>BP
Mono-in, Amb1 followed by 24dB/octave bandpass filter. ADJUST controls band fre-
quency.
4.6 Mono>Amb2>LP
Mono-in, Amb2 followed by 24dB/octave lowpass filter. ADJUST controls high frequency
cutoff.
4.7 Mono>Amb2>HP
Mono-in, Amb2 followed by 24dB/octave highpass filter. ADJUST controls low frequency
cutoff.
4.8 Mono>Amb3>LP
Mono-in, Amb3 followed by 24dB/octave lowpass filter. ADJUST controls high frequency
cutoff.
4.9 Mono>Amb3>HP
Mono-in, Amb3 followed by 24dB/octave highpass filter. ADJUST controls low frequency
cutoff.
ADJUST: Center
ADJUST: Depth
ADJUST: Spooky
ADJUST: Hi Cut
ADJUST: Lo Cut
ADJUST: Band
ADJUST: Hi Cut
ADJUST: Lo Cut
ADJUST: Hi Cut
ADJUST: Lo Cut
Lexicon
0–100
1–100
0–127
0–127
0–127
0–127
0–127
0–127
0–127
0–127