Guest Internet GIS-R4 Quick Start Manual

The Guest Internet Hotspot Internet gateway products (GIS-R2, R4, R5, R6 and R10) have Ethernet LAN ports
that can be used to connect wireless access points, Internet café kiosk computers, wired hotel rooms and
business center computers. The Internet (WAN) port must be connected to the DSL or cable modem
First connect the gateway

GIS-R2 Configuration

GIS-R2 Configuration
as shown in the diagram
to configure it using the
setup wizard.
Connect your computer
Ethernet connector to the
LAN1 connector of the
gateway. Your computer
Ethernet connector should
be configured for dynamic
IP or as a DHCP client. It
cannot be used with a fixed
IP.
Connect the Internet
connector of the gateway
to the DSL or cable
modem LAN Ethernet
GIS-R4 GIS-R4
connector. The DSL of
cable modem should have
the LAN network
connector configured as a
DNCP server. Check with
the equipment manual to
verify the LAN connector
configuration.
Computer Computer
For operation the WiFi
Hotspot users will use
the wireless network or
kiosk computers.
GIS-R6 GIS-R6
Connect wireless access
points and kiosk
computers to the
gateway LAN ports.
If you wish to connect
Computer Computer
more devices then
connect an Ethernet
DSL/Cable DSL/Cable
switch to one of the
router router
LAN ports.

Reset to Factory Defaults

: With the GIS-R2 powered up, use a paperclip to press the reset button
through the hole. Hold the reset button down for 10 seconds the release. All parameters will be reset.
Hotspot Gateway Product Setup - Quick Start Guide 1
Download the product manual at: http://www.guest-internet.com/gateway
LAN port LAN port
Configuration Configuration
computer computer
GIS-R5 GIS-R5
DSL/Cable router DSL/Cable router
Computer Computer
12volt power supply 12volt power supply
For 110/220volts For 110/220volts
GIS-R10 GIS-R10
48 volt power supply 48 volt power supply 48 volt power supply 48 volt power supply
Computer Computer
For 110/220volts For 110/220volts For 110/220volts For 110/220volts
DSL/Cable DSL/Cable

First Time Product Configuration

Connect your laptop computer to one of the LAN ports of the gateway.
Connect the Internet port to you DSL router.
Open your computer browser. Instead of your login page you will see the
GIS-R2 GIS-R2
page shown below. This page is the SETUP WIZARD.
DSL DSL
Or Or
Internet port Internet port Cable Cable
Internet Internet
Power over Power over
Ethernet Ethernet
PoE PoE
injector injector
DSL/Cable DSL/Cable
12volt power supply 12volt power supply router router
The setup process has four steps. Follow the instructions to type in the
For 110/220volts For 110/220volts
information requested on each page. Then click on the button to go to the
next page. When the setup process is completed your personalized
wireless Internet service will be ready for your guests to start using. The
setup process is shown overleaf: flip this page over to start the setup
process.
Login to the Admin pages at any time. Connect your computer to the
gateway via an Ethernet cable of wireless. Then open your browser and
12 volt power supply 12 volt power supply 12 volt power supply 12 volt power supply
type in the URL:
For 110/220volts For 110/220volts For 110/220volts For 110/220volts
router router
The username is
with the wizard.
When the page opens select the option you need in the menu. See the
manual for more information about configuration.
Support@guest-internet.com
http://aplogin.com/admin
admin the one
, and the password is that you entered
Copyright © Fire4 Systems Inc., 2011. All rights reserved.