Ford F-Super Duty 550 2004 Workshop Manual

2004 F-Super Duty 250-550/Excursion Workshop Manual

SECTION 206-05: Parking Brake and Actuation

REMOVAL AND INSTALLATION
Shoes—Rear Wheel
Special Tool(s)
Brake Adjusting Gauge
206-D002 (D81L-1103-A)
or equivalent
Removal
WARNING: Asbestos fiber dust can be present on brake and clutch assemblies
and is hazardous if inhaled. Brake and clutch assemblies must be cleaned using a
vacuum cleaner recommended for use with asbestos fibers such as a brake/clutch/
service vacuum. The bag must be labeled per OSHA instruction, sealed, and the
trash hauler notified as to the bag's contents. If a vacuum suitable for asbestos is
not available, cleaning must be done wet. If dust generation is still possible,
technicians must wear government-approved toxic dust purifying respirators.
WARNING: Occupational health and safety act (OSHA) requires areas where
asbestos dust generation is possible to be isolated and posted with warning signs.
Only technicians performing brake or clutch repair are to be present in the area.
1. Remove the rear disc brake rotor. For additional information, refer to
2. Disconnect the rear parking brake cable at the parking brake intermediate cable
(2A793).
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS4O/~MUS~LEN/19/S4O65007.HTM (1 of 8) [9/12/2009 12:39:36 PM]
Printable View (283 KB)
2004 F-Super Duty 250-550/Excursion
Procedure revision date: 05/24/2003
Workshop Manual
Section 206-04.