Appletalk Printing; Configuring The Print Server From Windows; Setting Up A Workstation To Print - Intel PCLA4251B - Netportexpress Pro Enet EXT 10BT Single Port Setup Manual

AppleTalk Printing

The NetportExpress print server supports AppleTalk. Printing requires an
AppleTalk zone and router.

Configuring the print server from Windows

1 On a Windows PC, start Netport Manager.
2 Select the print server. Match the Device ID in Netport Manager with the
Device ID located on the bottom of the print server. If the device is not
listed, see Troubleshooting on page 21.
3 Click the Config Wizard button.
4 Follow the directions in the wizard for AppleTalk.
Configuring the print server from Web Netport
Manager
Note: If the NetportExpress print server has an IP address, you can use your Web
browser to configure the print server. If you have a DHCP server on your
network, the print server will automatically get an IP address from the DHCP
server. If you don't have a DHCP server, install Netport Manager on a Windows
PC and run the Config Wizard to set an IP address.
1 In your Web browser, type the NetportExpress print server's IP address in
the Address or Location box and press Enter.
2 Click Configure and click AppleTalk.
3 Enter the name of the AppleTalk zone you want the NetportExpressä print
server to use.
4 Select a port by selecting the Enable checkbox.
5 Use the default settings for Chooser Name, Printer Type, and Font Group.
6 Click Submit.

Setting up a workstation to print

1 At a Macintosh workstation, from the Apple menu, select Chooser.
2 Select the printer driver for the printer connected to the NetportExpress
print server. If you're using a PostScript* printer, select the LaserWriter*
icon for your printer.
3 The Chooser window displays an AppleTalk zone list. Select the zone you
specified when you configured the print server.
4 Select the Chooser name for the NetportExpress print server you want the
Macintosh workstation to use.
5 Close the Chooser window.
13