Yaesu VX-8DR - APRS Manual page 143

DTMF S
Selects the DTMF Autodialer Delay Time.
Enables/Disables the DTMF Autodial feature.
Programming the DTMF Autodialer.
Selects the DTMF Autodialer Sending Speed.
S /K S
Set the duration that a secondary function of the [ F/W ] key (press and holding the [ F/W ] key) is held
determines the function they activate.
Selects the function of the [ H/M ] key.
Selects the Control Locking lockout combination.
Selects the MONI key (just below the PTT switch) function.
Selects the time delay before the carrier is transmitted, when the PTT switch is pressed.
Select the [ VOL ] key function.
D S
Indicates the DC Supply Voltage.
Selects the LCD/Keypad Lamp mode.
Setting the Display contrast level.
Setting the Display brightness level.
Illuminates the white LED light continuously (useful as emergency flashlight at night).
Selects the Opening Message that appears when the radio is powered on.
Selects the sensor information when the transceiver is operating in the "Mono" band mode with large
character.
Displays internal sensor information.
Selects the S- & TX PO meter Symbol.
Selects the Spectrum Analyzer sweep mode.
Calibrating the Sensor Unit.
Selects the measurement units of the Sensor Unit.
Selects the Wave-Form display while indicating the Wave-Form via Set Mode Item 84: SENSOR DISPLAY.
B S
Enables/Disables the Band-edge beeper while selecting the frequency with the DIAL knob.
Adjust the Beep volume level.
Create the Beep Melody for Bell ringer function.
Enables/Disables the keypad beeper.
Select the CW tone pitch for the CW Learning, CW Training, and CW Identifier functions.
M S
Select the antenna to be used for the AM Broadcast listening.
Select the antenna to be used for the FM Broadcast listening.
Enables/Disables the receiver Front-end Attenuator.
Enables/Disables the Busy Channel Lock-Out feature.
Selects the Channel Counter Search Width.
Shifting of CPU clock frequency.
Enables/Disables the CW Learning feature.
Enables/Disables the CW Training feature.
Enables/Disables the extended Set Mode Menu.
Reducing the Deviation level by 50 %.
Enables/Disables the function of the VFO DIAL knob, while in the Home Channel mode.
Selects the language for the Set Mode selections.
Adjusts the microphone gain level.
Adjusts the receiver audio output level when the MUTE function was activated.
Set the OFF Timer time.
Set the ON Timer time.
Programming and activating the Password feature.
Select the resume mode of the AF-Dual Operation.
Sets the receiving mode.
Selects the Set Mode Cursor.
Selects the display format of the Set Mode operation.
Selects the Smart Search Sweep mode.
Enables/Disables the FM Broadcast audio output to the internal speaker when using the earphone antenna.
Sets the Squelch threshold level.
Adjusts the Squelch threshold level to the S-meter level.
Setting of the DIAL frequency steps.
Enables/Disables the stereo output while receiving the FM Broadcast band.
Sets the Clock time.
Setting of the TOT time
Selects or disables the VFO band edge limiting for the current band.
Set My Band.
Enables/Disables VOX operation; sets VOX sensitivity.
Selects the VOX delay ("hang") time.
Enables/Disables the Weather Alert Feature
1: Depends on the operating band and transceiver version.
2: Depends on the transceiver version.
VX-8DR O M
S M I A
28: DTMF DELAY 50ms / 250ms / 450ms / 750ms / 1000ms
29: DTMF MANUAL/AUTO MANUAL / AUTO
30: DTMF SELECT --
31: DTMF SPEED 50mS / 100mS
S M I A
36: FW KEY HOLD TIME 0.3sec / 0.5sec / 0.7sec / 1.0sec / 1.5sec
39: HOME/REVERSE HOME / REV
51: LOCK KEY / DIAL / KEY&DIAL / PTT / KEY&PTT /
DIAL&PTT / ALL
61: MONI/T-CALL MONI / T-CALL
73: PTT DELAY OFF / 20ms / 50ms / 100ms / 200ms
107: VOLUME MODE NORMAL / AUTO BACK
S M I A
25: DC VOLTAGE --
46: LAMP KEY 2sec - KEY 10sec / CONTINUOUS /
OFF (KEY 5sec)
48: LCD CONTRAST LEVEL 12 ~ LEVEL32 (LEVEL24)
49: LCD DIMMER LEVEL 1 ~ LEVEL 4
50: LED LIGHT --
65: OPENING MESSAGE NORMAL / OFF / DC / MESSAGE
84: SENSOR DISPLAY DC / TEMP / WAVE / BARO / ALTI / WX / OFF
85: SENSOR INFORMATION --
89: S-METER SYMBOL Four patterns
91: SPEC-ANALYZER 1Time / Continuous / Full Time
103: UNIT OFFSET BARO: -1000 ~ 0 ~ +1000,
ALTI: -1000 ~ 0 ~ +1000
104: UNIT SELECT TEMP: °C / °F ,
BARO: hPa / mb / mmHg / inch ,
ALTI: m / ft
110: WAVE MONITOR ALL / RX SIGNAL / TX MODULATION
S M I A
10: BEEP EDGE ON / OFF
11: BEEP LEVEL LEVEL 1 - LEVEL 9 (LEVEL 5)
12: BEEP MELODY --
13: BEEP SELECT KEY & SCAN / KEY / OFF
23: CW PITCH 400 - 1000 Hz (50 Hz/step) (700 Hz)
S M I A
1: ANTENNA AM BAR & EXT / BAR ANTENNA
2: ANTENNA FM EXT ANTENNA / EAR PHONE
3: ANTENNA ATT ON / OFF
9: BCLO ON / OFF
19: CH COUNTER ±5 MHz / ±10 MHz / ±50 MHz / ±100 MHz
20: CLOCK SHIFT ON / OFF
22: CW LEARNING --
24: CW TRAINING --
35: EXTENDED MENU ON / OFF
37: HALF DEVIATION ON / OFF
38: HOME VFO DISABLE / ENABLE
47: LANGUAGE ENGLISH / JAPANESE
60: MIC GAIN LEVEL 1 ~ LEVEL 9 (LEVEL 5)
62: MUTE MUTE 30%,MUTE 50%, MUTE 100%, or OFF
63: OFF TIMER --
64: ON TIMER --
69: PASSWORD --
77: RX AF DUAL TRX 1sec ~ TRX 10sec /
HOLD / TX 1sec ~ TX 10sec (TRX 2sec)
78: RX MODE AUTO / NFM / AM / WFM
86: SET MODE CSR Nine patterns
87: SET MODE FORMAT LIST / ITEM
88: SMART SEARCH SINGLE / CONTINUOUS
90: SPEAKER OUT AUTO / SPEAKER
92: SQL LEVEL LEVEL 0 ~ LEVEL 15 (LEVEL 1)
LEVEL 0 ~ LEVEL 8 (LEVEL 2)
93: SQL S-METER OFF / LEVEL 0 ~ LEVEL 9
96: STEP FREQUENCY AUTO / 5.0 /6.25 / 8.33 / 9.0 / 10.0 / 12.5 / 15.0 /
20.0 / 25.0 / 50.0 / 100 kHz
97: STEREO STEREO / MONO
98: TIME SET --
102: TOT OFF / 0.5min ~ 10.0min (0.5min/step) (3.0min)
105: VFO MODE ALL / BAND
106: VFO SKIP --
108: VOX OFF / HIGH / LOW
109: VOX DELAY 0.5sec / 1.0sec / 2.0sec
111: WX ALERT ON / OFF
S M
ET ODE
V D : B I
V D : B I
V D : B I
V D : B I
V D : B I
(AM and Narrow FM),
(Wide FM and AM Broadcast)
141