Cw Training Feature - Yaesu VX-8DR Operating Manual

CW T
RAINING
The VX-8DR provides another CW learning feature; call it a CW Training feature, which
sends random Morse Code via the sidetone (heard in the speaker), so you can improve
your CW proficiency.
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 24: CW
TRAINING.
3. Press the key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select the Training mode (displayed
in fine print at the upper edge of the LCD):
ALPHA 5CHR:
ALPHA REPT:
NUMBER 5CHR: Sends five Numeric characters only
NUMBER REPT: Sends Numeric characters only (Repeatedly)
MIX 5CHR:
MIX REPT:
key to change the cursor to "SPED", then rotate the DIAL knob to select
5. Press the
the Morse speed. You may select the units of the code speed between "CPM (charac-
ters per minute)" and "WPM (Words per minute)" by the DIAL knob from Set Item
"FORM".
6. Press the
rotate the DIAL knob to adjust the CW sidetone pitch (400
- 1000 Hz, 50 Hz/step).
7. Press the key to change the cursor to "LED", then rotate
the DIAL knob to switch the flashing of the (white) LED light "on" and "off".
8. Press the /
9. Press the key to begin generation of the code characters
(CW sidetone only, the radio does not transmit); the gener-
ated characters will appear at the right of the "CHR" item.
10. You may adjust the CW sidetone audio level by rotating the
DIAL knob while pressing and holding the
11. If one of the "5CHR" modes is selected in step 4 above, press the
another code group.
12. To stop CW generation, press the
13. To disable CW training feature, press the PTT switch.
The "CPM" selection is based on the international "PARIS" standard, which
stipulates five characters per word.
118
F
EATURE
key for one second to enter the Set Mode.
Sends five Alphabet characters only
Sends Alphabet characters only (Repeat-
edly)
Sends five Alphabet, Numeric, "?", and "/" characters (Mixed)
Sends Alphabet, Numeric, "?", and "/" characters (Mixed, Con-
tinuously in groups of five)
key to change the cursor to "PTCH", then
key to change the cursor to "SPED.
key.
key again.
VX-8DR O
key to send
M