User Set Mode - Yaesu VX-451 Operating Manual

The VX-450 Series includes a "User Set (Menu)"
Mode which allows the user to define or configure
various settings, such as Beep On/Off, Squelch, etc.
To activate the "User Set (Menu)" Mode:
Press (or press and hold) the programmable key
assigned to the "SET" function.
Select the User Set Mode Item you wish to change
using the [ A ] / [ B ] keys, then use the [ SIDE-1 ] /
[ SIDE-2 ] button to adjust the setting of the se-
lected item.
Press the [ D ] key to store the new configuration.
The display indicates "- SET -" briefly, then exits
to normal operation.
You may cancel the selection by pressing the [ C ]
key. The display indicates "- CANCEL -" briefly,
then exits to normal operation.
U S M
D
1 SQL
2 BEEP
3 BELL
4 LIGHT
5 KEY
6 DIAL
7 PTT
8 SCAN
9 DW
10 AF
11 VOX
12 TX SV
13 ENCR
14 REC
15 PLAY
: The menu "14: REC Mode" and "15: Play Mode" will ap-
pear only when the Voice Recording Unit is installed.
D
Select the Squelch Threshold Level (–15 to +15)
Set the Beep ON / OFF
Set the Bell ON / OFF
(Bell engaged by sub-audible CTCSS/DCS)
Set the BUSY/TX LED and Lamp ON / OFF
Set the Key Lock function ON (Lock) / OFF (Free)
Set the DIAL Lock function ON (Lock) / OFF (Free)
Set the PTT Lock function ON (Lock) / OFF (Free)
Set the Scan status
OFF: Stop the Scan
ON: Start the Scan
GRP: Start the Group Scan
FM: Start the Follow-Me Scan
Set the Dual Watch ON / OFF
(same function as DW key)
Set the Minimum Volume level (000 to 255)
Set the VOX level
Set the TX Saver ON / OFF
Set the Encryption ON / OFF
(This menu will appear only when the Encryption
setting of the current channel is set to "Key ON"
or "Power ON".)
ONE: Enables recording one message (max. 120
seconds), and playback from the beginning
of the message.
ROL: Enables recording whenever squelch
opens, and playback of the last 120 sec-
onds.
Set the priority audio on playback mode.
PLY: Playback audio is higher priority than re-
ceived signal
SIG: Received signal is higher priority than play-
back audio
VX-450 S O M