Advertisement
5. On your computer desk top open PEP9000_EDSP folder and find the EDSP9000 V201 icon as
shown below. Double-click the EDSP9000 V201 icon, displayed on the Program Screen.
6. Click the Update button. You will see AH010H_V1154 out file displayed. If you do not see
AH010H_V1154 (as in the screen below), then open the "Look in:" window and go to the desktop
and find PEP9000_EDSP. Open the folder and AH010H_V1154 will be displayed in the
window. Click AH010H_V1154 out file to
the program is loaded, and 100% is indicated on the bar graph, [Completion!!!] will be displayed.
7. Turn the front Power Switch and the Main Power Switch in the back OFF (or turn off the power
supply for FT
9000MP and wait a minute, until the capacitors discharge) and remove the AC
DX
power cord. This resets the radio and locks in the new software. Remove the DB9F to DB9F
cable. The updating process is now complete
It is important to reset the FTDX9000. Plug the radio back in. Press and hold in the [FAST] and
[LOCK] keys; while holding them in, turn the radio back on (this resets the radio and locks in the
new software).
NOTE: We recommend trying the new factory default settings rather than transferring your old ones,
because of the changes in the EDSP and the Main CPU, you may wish to make new settings.
We hope this new software will increase your enjoyment of your FT
Yaesu radios. If you have any problems or questions please contact Vertex Standard, Amateur Tech
Support.
amateurtech@vxstdusa.com
Best regards,
Mikio Maruya, WA6F
Executive Vice President
Engineering & Customer Service
Vertex Standard USA, Inc.
Vertex Standard USA, Inc. | 10900 Walker St. | Cypress, CA 90630 | 714.827-7600 | FAX: 714.827-8100
highlight
it. Then click the Open button and wait until
NOTE: If you receive a "Communications
Error" message on your screen you should
check the COM port number and speed under
Device Manager. The writing speed 38.4kbps
is fixed in the download algorithm of the EDSP
board so you may need to set the port speed
close to 38.4kbps. Click on the COM Select
box arrow and choose a different COM port
from the drop down menu in the EDSP9000
writer.
www.vertexstandard.com
9000. Thank you for choosing
DX
Advertisement
