Advertisement
4. While holding the [DNR]＋[CONT] for the D or [NR]＋[CONT] buttons for the Contest and
MP, press the front main power switch to turn the radio on. You will see
display.
5. On your computer desk top open PEP9000_EDSP folder and find the EDSP-9000 icon as shown
below. Double-click the EDSP-9000 icon, displayed on the Program Screen.
6. Click the Update button. You will see AH010N_V1153 out file displayed. If you do not see
AH010N_V1153 (as in the screen below), then open the "Look in:" window and go to the desktop
and find PEP9000_EDSP. Open the folder and AH010N_V1153 will be displayed in the
window. Click AH010N_V1153 out file to
the program is loaded, and 100% is indicated on the bar graph, [completion!!] will be displayed.
7. Turn the front Power Switch and the Main Power Switch in the back OFF (or turn off the power
supply for FTdx9000MP and wait a minute, until the capacitors discharge) and remove the AC
power cord. This resets the radio and locks in the new software. Remove the DB9F to DB9F
cable. The updating process is now complete
It is important to reset the FTdx9000. Plug the radio back in. Press and hold in the [FAST] and
[LOCK] keys; while holding them in, turn the radio back on (this resets the radio and locks in
the new software).
NOTE: We recommend trying the new factory default settings rather than transferring your old ones,
because of the changes in the EDSP and the Main CPU, you may wish to make new settings.
highlight
it. Then click the Open button and wait until
NOTE: If you receive a "communications
error" message on your screen you should
check the COM port number and speed under
Device Manager. The writing speed 38.4kbps
is fixed in the download algorithm of the EDSP
board so you may need to set the port speed
close to 38.4kbps. Click on the COM Select
box arrow and choose a different COM port
from the drop down menu in the EDSP9000
writer.
[dSP
Prg] on the radio
Advertisement
