3/16/10
This procedure is used to update the flash programming for
the DMU-2000.
V4.21 or V5.11 version software is ONLY needed when the DMU-2000 is used with the New
FTdx5000 Transceiver. There is no change from V4.20 or V5.10 when used with the FT-2000/D
or FT-950 radios. If you already have System File [CF1] V0.08 or V0.09 you only need to install
the [CF2] V4.21 or V5.11 application file.
* This is the latest software and is compatible with all three FT-950, FT-2000/D and FTdx5000 series.
Check which version DMU software you have on your unit.
While holding the three buttons [GEN]+[50]+[ENT] turn the radio on. The software version will be
displayed in the lower right of the VFO-A window (FTdx5000 version will be shown in the Center
OLED display) for 5 seconds then the radio will start up in normal operation. Example: DMU-2000
software version 0511.
FTdx5000
Two types of computers are used in the DMU-2000. You must use the correct software for
your computer.
•
If you have version
have the latest software and do not need to update.
•
If you have
05xx
you must download V0.09/5.11. If you have V0511 you have the latest
software and do not need to update.
*You may also check the software level on the DMU boot up screen.
main power to boot the DMU processor. IF the YAESU boot up screen shows this small Phoenix BIOS
logo at the lower right of the screen, you have version
the Phoenix logo is not shown, you have version
PC
After you confirm the type of software it is very important that you only down load the correct
version from the Yaesu website.
FT-2000/D
03xx or 04xx
you must down load V0.08/V4.21. If you have V0421 you
SYSTEM (OS)
Ver.0.08
Ver.0.09
PC
Software Version:
05xx.
If you already have software Ver.
0421 or 0511 it is not necessary to
update the DMU-2000 again.
(This image & version is for illustration
only)
Turn on the DMU front and rear
05xx
and must download
03xx or 04xx
you must down load
APPLICATION
Ver.4.21
(03xx or 04xx)
Ver.5.11
(05xx)
03xx, 04xx or
V0.09/5.10.
If
V0.08/V4.20.