CONCORD EYE-Q GO! User Manual page 8

LOADING THE BATTERY
Before taking pictures, a fresh 3V (CR123A) Lithium
battery must be inserted into the unit.
1. Using your thumb, open the battery compartment
by pressing down on the battery door and
sliding it outwards as indicated by the arrow.
2. Insert a 3V (CR123A) Lithium battery. Make sure
to observe the polarity (+/–) as indicated in the
figure.
3. Close the battery compartment.
The camera has a battery indicator that shows the current battery level,
regardless of the mode the camera is in.
Battery
power and is ready
to use.
When battery is low, discontinue use and replace the battery.
Follow these precautions when using a battery in this device:
1. Use only the size and type specified.
2. Be sure to follow the correct polarity when installing the battery. A
reversed battery may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the
battery to prevent damage or injury from battery leakage.
GETTING STARTED
FULL
has full
BATTERY PRECAUTIONS
LOW
Battery has
power and
need to be replaced
soon.
6
low
will