Installing Tilt Brackets - NEC E551 Installation And Assembly Manual

Installing Tilt Brackets

• Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached.
Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
2
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the tilt brackets to be attached. Place
tilt brackets (B and C) on back of screen as shown below. Note: Be sure to attach tilt brackets with handles facing
outward as shown below. Attach the tilt brackets to the back of the screen with M6 x 16 mm socket pin screws (G) and
multi-washers (I). Verify that all holes are properly aligned, and then tighten screws using security allen wrench (F).
WARNING
G
I
SCREEN
HANDLES
FACE OUT
6 of 7 ISSUED: 07-28-10 SHEET #: 125-9132-1