Installing Tilt Brackets - NEC E321 Installation And Assembly Manual

Use Chart to Determine

Installing Tilt Brackets

fig 2.2
400 mm
200 mm
300 mm
USE TILT BRACKET ONLY
WHEN MOUNTING TO
SCREEN USING 200 X 200
2 To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the tilt brackets to be attached. Place
tilt brackets (B and C) on back of screen as shown in fig. 2.2. Note: Be sure to attach tilt brackets with handles facing
outward as in figure 2.2. Align tilt brackets to screen mounting holes as recommended by chart below. Attach the tilt
brackets to the back of the screen using the appropriate combination of screws, either M6 x 12 mm socket pin screw
(G), M6 x 20 socket pin screw (H) or M8 x 15 mm socket pin screw (J) and multi-washers (I) as shown in figures 2.3
and 2.4. Verify that all holes are properly aligned, and then tighten screws using security allen wrench (F).
B
G, H
or J
USING TILT BRACKETS ONLY
Orientation
and Screws
MAX Distance 400 mm
HANDLES
FACE OUT
Landscape
Portrait
*
Use multi-washers (I) to attach tilt
brackets (B and C) to your screen
when using M6 x 12 mm socket pin
screw (G), M6 x 20 socket pin
screws (H).
M8 screws do not require
multi-washers (I)
I*
C
fig 2.3
WARNING
• Tighten screws so adapter brackets are firmly
attached. Do not tighten with excessive force.
Overtightening can cause stress damage to screws,
greatly reducing their holding power and possibly
causing screw heads to become detached. Tighten to
40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen
inserts or if screws bottom out and bracket is still not
tightly secured, damage may occur to screen or
product may fail.
G, H
I*
or J
6 of 7 ISSUED: 03-26-10 SHEET #: 125-9106-3 08-04-10
Secure extension brackets (L) to left
tilt bracket (B) with four M5 x 6 mm
socket pin serrated washer head
screws (K).
Height of tilt brackets may be
adjusted using holes above and
below center mounting location
holes.
NOTE: Repeat using right tilt
bracket (C).
K
L
fig 2.1
B
C
USING EXTENTION BRACKETS
B
CENTER
MOUNTING
LOCATIONS
fig 2.4