Software Installation - COMPRO X800 - START UP GUIDE Manual

Software Installation

After installing the PCI card and cables in your computer, you should restart it
and follow these steps to install the software.
Step 1. After restarting, Windows will detect your VideoMate TV card and start
the Add/Remove Hardware Wizard, prompting you to install the
VideoMate TV drivers. Please press Cancel and go to the next step.
Step 2. Insert the installation CD into your CD drive. If you have Autorun
enabled, the installer will start automatically. (If Autorun is disabled,
double-click on "setup.exe" on the installation CD.) You can choose
Complete to install all necessary software (VideoMate TV drivers,
ComproPVR 2, ComproDVD 2, ComproFM 2, Ulead PhotoExplorer
8.5 SE) or choose Custom to select item by item. Compro
recommends you choose Complete. ComproFM 2 is not available for
all models.
Step 3. If you see the Windows Logo testing message, below, please press
"Continue Anyway" to proceed.
Step 4. Press Next to install ComproPVR 2, ComproDVD 2, ComproFM 2,
Ulead PhotoExplorer 8.5 SE.
Step 5. When installation completes, press Finish to restart computer.
ComproPVR 2 needs to use components of Ulead PhotoExplorer 8.5. If your
computer doesn't have PhotoExplorer, ComproPVR 2 will fail to record.
Please reinstall Ulead PhotoExplorer 8.5 from installation CD.
Note
Continue
11