Xylem JABSCO 36760-0115 FLANGEMOUNT Manual

CONTINUOUS DUTY 4" BLOWER
• 115 VOLT AC, 60 Hz
• 220 VOLT AC, 50 Hz
FEATURES
• Extended Life Induction Motor
• Tough Reinforced Thermoset Plastic Housing
• Continuous-Duty Motor with
Thermal Overload Protection
• Flangemount Mounts to any Flat Surface
• Flexmount Universal Bracket Permits Outlet to
Face any Direction
• Slip-on Inlet Ducting Connection
• Efficient High Volume Air Flow
• Low Current Draw
WARNING
!
Explosion hazard. Motor can spark. Explosion
& death can occur. Do not use where flammable
vapors are present.
• Corrosion-Resistant Materials Throughout
APPLICATION
The Jabsco AC blowers are ideal for ventilating equipment
areas. They may also be used for engine room ventilation on
vessels with diesel powered engines only. THIS BLOWER IS
NOT IGNITION PROTECTED. DO NOT USE TO EXHAUST
FLAMMABLE VAPORS SUCH AS GASOLINE FUMES OR
MOUNT IN AN AREA WHICH MAY CONTAIN FLAMMABLE
FLEXMOUNT INSTALLATION
Mount blower on flat bulkhead surface in highest part of com-
partment free from spray or deck wash. Blower may be rotated
in mounting bracket to facilitate the shortest route of ducting.
SPECIFICATIONS - Flexmount
Air
Model Flow Voltage Amps Size lb (kg)
36770-0115 250 CFM
(7.0 m /min)
3
36770-0220 200 CFM
DIMENSIONAL DRAWING – Flexmount
9-1/8
(232)
4
(102)
9-3/16
(233)
Fuse Weight
115 AC 1.5 2A 9 (4.1)
60Hz AGC
220 AC .35 .5A 9 (4.1)
4
(102)
9-7/8
(250)
MODELS 36760-0115 FLANGEMOUNT
36760-0220 FLANGEMOUNT
36770-0115 FLEXMOUNT
36770-0220 FLEXMOUNT
Flexmount
WIRING
All wiring should be done by a qualified electrician and con-
form with regulations. A minimum of 16 gauge THW wire
should be used for lengths of up to 50 feet from the power
source. A separate ground wire should be secured to the
grounding wire attached to the motor case and connected to
a common ground. A switch of minimum 2 Amp rating may
also be installed in the hot electrical lead (between breaker
and blower) to control blower operation. The neutral conduc-
tor should be connected directly from the neutral buss to the
blower motor.
WIRE COLOR CODE
Models Ground
(earth)
115 Volt Green
FLANGEMOUNT INSTALLATION
The blower housing flange should be mounted on a flat bulk-
head surface. Selection of a dry cool location will prolong motor
life. When location is selected, cut a 3-5/8" hole through bulk-
head to align with discharge port of blower. Secure discharge
port flange to bulkhead using #10 screws and flat washers.
Tighten screws evenly to avoid flange damage.
SPECIFICATIONS - Flangemount
Air
Model Flow
36760-0115 250 CFM
(7.0 m /min)
3
36760-0220 200 CFM
DIMENSIONAL DRAWING – Flangemount
4
(102)
8-3/4
(222)
Flangemount
Common Line
(neutral) (positive)
White Black
Fuse Weight
Voltage Amps Size lb (kg)
115 AC 1.5 2A
60Hz AGC
220 AC .35 .5A
3-5/8
(92)
9
(229)
9-7/8
(250)
8 (3.6)
8 (3.6)