Installation - COMPRO U880 - START UP GUIDE Manual

Installation

Start the computer. Make sure VideoMate U880 is connected to your computer
and insert the installation CD into your CD drive.
Step 1. After restarting, Windows will detect a new device and start the
Add/Remove Hardware Wizard. Please press Cancel and go to the
next step.
Step 2. Insert the installation CD into your CD drive. If you have Autorun
enabled, the installer will start automatically. (If Autorun is disabled,
double-click on "setup.exe" on the installation CD.) You can choose
Complete to install all necessary software (VideoMate U880 drivers,
ComproPVR, ComproDVD, Ulead PhotoExplore 8.5 SE) or choose
Custom to select item by item. Compro recommends you choose
Complete.
Step 3. If you see the Windows Logo testing message, below, please press
"Continue Anyway" to proceed.
Step 4. Press Next to install ComproPVR, ComproDVD, Ulead PhotoExplorer
8.5 SE.
Step 5. After each program is successfully installed, press Finish to proceed.
Step 6. When installation completes, press Finish to restart computer.
Step 7. Connect TV signal.
Step 8. Open ComproPVR to enjoy the show.
4
Continue Anyway