GEL BLASTER SURGE Manual

STEP 1 - CHARGE YOUR BLASTER
Use the provided USB-C cord to charge your blaster. Do not place your charging blaster on
any fabric surface during charging. Do not leave blaster charging for an extended period
of time, unplug it when the indicator light turns green.
STEP 2 - FILL YOUR HOPPER
Fill your hopper with hydrated Gellets® – make sure all water is drained from the
hopper before installing on your blaster. Discard any unused hydrated Gellets
after play.
STEP 3 - INSTALL HOPPER ONTO BLASTER
Screw the full hopper into the blaster feedneck, then flip your blaster upside down to
slide the feedneck onto the top rail of the blaster with the arrow pointing forward.
IMPORTANT - Make sure you slide the feedneck all the way forward until you feel and
hear a "click". Failing to do so will cause your blaster to misfire.
STEP 4 - OPTIONAL: INTERCHANGEABLE BARRELS
Your blaster currently comes with the Standard Barrel pre-installed. To remove the barrel,
use the Barrel Tool provided to unscrew the barrel. You can then install your orange
Reduced Velocity Barrel for a lighter blasting experience.
STEP 6 - PROTECT YOUR EYES!
Wear the provided eye protection when using your blaster. Do not blast at people unless
they're using proper eye protection.
STEP 7 - POWER ON AND HAVE A BLAST!
Switch between Single and Full-Auto with the Blaster Mode Switch.
Your blaster is not intended to
get wet. Don't submerge your
Gel Blaster® product in water,
and make sure your Gellets® are fully
strained of excess water. This will protect
the internals within from failure.
STATUS LIGHTS HOPPER INSTALL
BATTERY
INDICATORS
USB-C CHARGING PORT
SWAP FINS & TIPS
FINS
NOTCH
SIDE UP
TIP
BLASTER MODE SWITCH CHANGE BARREL
TO REMOVE, ROTATE
SINGLE OFF FULL-AUTO
COUNTER-CLOCKWISE
BARREL
FEEDNECK
CLEAR
HOPPER
FINS
NOTCH
SIDE UP
TIP
BARREL TOOL