STEP 1
- CHARGE YOUR BLASTER
Use the provided USB-C cord to charge your blaster. Do not place your charging blaster on any fabric
surface during charging. Do not leave blaster charging for an extended period of time, unplug it when
the indicator light turns green.
STEP 2
- INSTALL (2) AAA BATTERIES IN YOUR ACTIVATOR
To install batteries, remove the Starfire Activator feedneck by pulling it towards the back of your
blaster. Once removed, locate the green door to the battery compartment. Loosen the screw in the
battery compartment cover using a Phillips screwdriver and lift. Insert two "AAA" batteries as indicated
inside the battery compartment. Follow the markings on the product for correct installation. Replace
the battery compartment cover and tighten the screw using a Phillips screwdriver.
IMPORTANT: DO NOT OVERTIGHTEN
STEP 3
- FILL YOUR HOPPER
Fill your hopper with hydrated Gellets – make sure all water is drained from the hopper before
installing on your blaster.
The Gel Blaster Starfire Activator will accommodate all gellets but will only
charge Starfire Gellets for glow in the dark play.
STEP 4
- INSTALL HOPPER ONTO BLASTER
Screw the full hopper into the Starfire feedneck, then flip your blaster upside down to slide the
feedneck onto the top rail of the Starfire with the arrow pointing forward.
IMPORTANT - Make sure you slide the feedneck all the way forward until you feel and hear a "click".
Failing to do so will cause your Starfire to misfire.
STEP 5
-
OPTIONAL:
INTERCHANGEABLE BARRELS
Your Gel Blaster currently comes with the Standard Barrel pre-installed (175fps). To remove the barrel,
use the Barrel Tool provided to unscrew the barrel. You can then install your orange Reduced Velocity
Barrel (100fps) for a lighter blasting experience.
STEP 6
- PROTECT YOUR EYES!
Put on your provided eye protection when using your Gel Blaster StarFire. Make sure that others within
firing distance are wearing eye protection too! Do not shoot at people not wearing proper eye-wear.
STEP 7
- POWER ON AND HAVE A BLAST!
Press the power button on the Starfire Activator. The UV light ring will power on and charge Starfire
Gellets during gameplay. Switch between Single and Full-Auto with the Blaster Mode Switch.
WARNING: Don't submerge
your Gel Blaster in water, and
make sure your Gellets are
fully strained of excess water. This will
protect the batteries and circuitry
within from failure.
STATUS LIGHTS
REMOVE FEEDNECK
BATTERY
INDICATORS
PULL
USB-C CHARGING PORT
POWER
UV LIGHT
BUTTON
RING
BATTERY
COMPARTMENT
COMPARTMENT
SCREW
+
-
CHANGE BARREL
BLASTER MODE SWITCH
TO REMOVE, ROTATE
SINGLE OFF FULL-AUTO
COUNTER-CLOCKWISE
BARREL
BARREL TOOL
FORWARD
INDICATOR
Need help?
Do you have a question about the STARFIRE and is the answer not in the manual?
Questions and answers