Signature Hardware 329555 Installation Instructions

SHOWER HEAD
INSTALLATION INSTRUCTIONS
Before you begin, read the installation instructions below. Observe all local plumbing and building codes.
For the following installation instructions for your new shower head it is assumed that any old fixtures have been
removed and all rough-in work has been completed.
Unpack and inspect the shower head for any shipping damages. If you find any damages, do not install. Contact
Customer Service at 1.866.855.2284. If you need assistance while installing your new shower head, call Customer
Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures and plumbing. Signature
Hardware accepts no liability for any damages to the floor, walls, plumbing or personal injury during installation.
Shut off the water supply lines where the new shower head is being installed.
TOOLS AND MATERIALS:
Groove Joint Pliers
Dry Cloth
Damp Cloth
INSTALLATION
1. Apply plumber's tape to the threads on both ends of the shower arm and slide on the decorative escutcheon.
2. Insert the new arm into the fitting in the wall or ceiling and twist to tighten. Finish tightening with your adjustable
wrench. Wrap a dry cloth around the shower arm to protect the finish while tightening with adjustable wrench.
Note: If your shower head does not feature a shower arm, connect the shower head directly to the fitting in the wall
or ceiling.
3. Thread the new shower head onto the arm and hand-tighten. Hold the shower arm in place with groove joint pliers
and finish tightening the shower head with your adjustable wrench. Wrap both in a dry cloth to protect the finish.
4. Before securing the decorative escutcheon to the wall, turn on the water supply to make sure that all connections are
tight and there is no leaking. If no leaks are detected, continue with the installation. If leakage does occur, use your
adjustable wrench to tighten the connections as necessary. If problems persist, contact Customer Service at
1-866-855-2284.
5. Apply a bead if silicone sealant to the back of the escutcheon and press firmly into place against the installation
surface. Wipe away any excess sealant with your damp cloth.
6. Install the handle faceplate with the installation hardware.
7. Make sure the valve is in the OFF position and install your shower handle. Tighten the set screw in the middle or
side of the handle to secure the handle in place.
Adjustable Wrench
Phillips Screwdriver
Allen Wrench (provided)
Plumber's Tape
Silicone Sealant
Shower Head Installation Instructions 1