Vangoa B08FHTSNJQ User Manual

ATTENTION ：
Thank you for choosing Vangoa Fog Machine. Prior to use, we suggest that
you carefully read all of the instructions. Please follow these operation, safety
and maintenance instructions to ensure a long and safe life for your fog machine.
CAUTION:
Risk of electric shock. Disconnect the appliance from the electric supply
before refilling liquid, cleaning or performing maintenance on the machine.
Danger of Electric Shock
1. Keep this device dry.
2. For inside use only. Not designed for outside use.
3. For all models, use 3-prong grounded electrical outlet only. Prior to use take
care to determine that the unit is installed at the rated voltage.
4. Always unplug the Fog Machine before filling its tank.
5. Always keep fog machine in upright position.
6. Turn off or unplug the machine when not in use.
7. This machine is not water-proof. If moisture, water, or fog fluid gets inside
the housing, immediately unplug the unit and contact a service technician or
Vangoa before using it again.
8. No user serviceable parts inside. Refer to Vangoa or other qualified service
personnel.
Danger of Burns
1. This device is for adult use only and must be installed out of the reach of
children. Never leave the unit running unattended.
2. Never aim the output nozzle directly at people.
3. Fog machine output is very hot. Avoid coming within 50 cm of the output
nozzle during operation.
4. Locate the fog machine in a well-ventilated area. Never cover the unit's
vents. In order to guarantee adequate ventilation, allow a free air space of
at least 20 cm around the sides and top of the unit.
5. Never aim the output nozzle at open flames. If the supply cord is damaged,
it must be replaced by manufacturer or its service agent or similarly qualified
personnel in order to avoid a hazard.
6. The output nozzle becomes very hot during operation (200°C). Keep flammable
materials at least 100 cm away from the fog machine. (Don't touch the machine
when it is operating, the surface is up to 40-80°C)
7. Always allow the Fog Machine to cool down before attempting to clean or service it.
Danger of Explosion
1. Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
2. Use only high-quality, water-based fog liquid that your dealer recommends.
Other fog liquids may cause clogging or "spitting".
3. Always make sure there is sufficient liquid in the tank. Operating this unit without
liquid will cause damage to the pump as well as over-heating of the heater.
4. If the Fog Machine fails to work properly, discontinue use immediately.
Drain all fog liquid from the tank, pack the unit securely (preferably
in the original packing material), and reach Vangoa for service.
5. Always drain tank before mailing or transporting this unit.
6. Never drink fog liquid. If it is ingested, call a doctor immediately.
If fog liquid comes in contact with skin or eyes, rinse thoroughly with
water. Pay attention to all warning labels and instructions printed on
the exterior of Vangoa Fog Machine.
Unpacking & Inspection
1. Unbox to check whether all necessary spare parts include accord the
specification list. Please contact us if there are something missed.
2. Check the appearance of machine and power line to see whether they
have some obvious damage. In the event that the unit's housing or
cable is damaged, do not plug it in and do not attempt to use it until
after contacting us for assistance.
3. Please contact us once you find anything problematic and stop to
use fog machine.
Setup
1. Remove all packing materials from shipping box. Check that all
foam and plastic padding is removed, especially in the nozzle area.
2. Place fog machine on a flat surface and remove fog liquid tank cap.
3. Place the liquid tube into a properly filled liquid tank. Fill with
high-quality, water-based fog liquid. Poor quality liquid can damage
the unit resulting in spitting and serious clogging problem.
4. When filled, place cap back on liquid tank. Be careful not to exceed
the maximum fluid level.
5. DO NOT OVERFILL.
Operation
1. Plug power cord into a grounded electrical outlet.
2. Turn the power switch to "ON" on the back of the machine. The unit
will start to warm-up the machine.
3. During this time the machine cannot generate any fog. The red LED
of the receiver will light on and stay ON when the warm-up process
is complete.
4. Press unlock button, the machine will spray fog. Press the lock
button to stop spraying.
5. You can place the machine in high position using its hanger or place
it on the ground. Please do not allow the unit to have more than a 25
degree angle of inclination.
IMPORTANT:
1. Always monitor tank fluid level as you are fogging.
2. Never drink Fog liquid. If it is ingested, call a doctor immediately.
3. If fog liquid comes in contact with skin or eyes, rinse thoroughly
with water.