Vangoa LED-500 User Manual

4. Always replace the caps on the fog liquid container immediately after
filling to avoid contamination.
5. If you experience low output, pump noise or no output at all, unplug immediately.
Check fluid level, the external fuse, and power from the wall. If all of the above
appears to be O.K., plug the unit again. If fog does not come out after holding the
remote button down for 30 seconds, check the hose attached to the tank to make
sure there is fluid going through the hose. If you are unable to determine the cause
of the problem, do not simply continue pushing the remote button, as this may
damage the unit. Please turn to us for help.
Performance Note
All fog machines develop condensation around the output nozzle. Because this may
result in some moisture accumulation on the surface below the output nozzle, consider
this condensation when installing your unit.
All fog machines may sputter small amounts of fog occasionally during operation
and for a minute or so after being turned off.
All fog machines have a recycling period after long bursts when the machine will
shut itself down for a short period in order to heat up again. During this time no
fog can be produced.
Cleaning and Storage
Do not allow the fog liquid to become contaminated. Always replace the caps on
the fog liquid container and the fog machine liquid tank immediately after filling.
Cleaning your fog machine regularly can help you to reduce the frequency of parts
replacement and the cost of maintenance. After every 40 hours of continuous
operation, it is recommended to use distilled water to clean the heater as per
following steps:
The recommended cleaning regimen is as follows:
1. Fill proper distilled water into a clean tank and connect the fluid tube of the
fog machine to the tank.
2. Run the unit in a well-ventilated area until the tank is almost empty.
3. Use dry cloth to wipe the fog machine. Cleaning is now complete. Refill with fog
liquid. Run the machine briefly to clear any remaining liquid from the pump and heater.
Note:
All fog machines are prone to clogging due to the thick consistency of fog liquid and
the high temperature at which it vaporizes. However, a properly maintained fog
machine should provide years of reliable use.
Clean with A Dry Cloth Only, Store It in A Cool Dry Place
If the fog machine is not in use, please clean it before storage. Store the fog machine
in a dry and cool place. At least operate the fog machine once a month. A test-run
consisits of warming-up the machine followed by a few minutes of fog emission.
User Manual
Mini Fog Machine
Please read this manual carefully before operation
If you have any questions, please feel free to contact us:
Website: www.vangoa.com Facebook: @vangoaofficial
Email: cs@vangoa.com Instagram: @vangoa_music
Made in China