Maxxhaul 70422 Quick Setup Manual

Hitch Mount Aluminum Cargo Carrier
Model 70422
Quick Set-Up Guide
Read Instruction Manual for attaching Hitch
Mount Aluminum Cargo Carrier.
Step 1
rear of cargo carrier), insert two Screws (2) through side
carrier basket using Spring Washer (4) and Nut (5).
back Long Edge(12)
Screw(2)
Step 2
Align the hole openings on Support Plate(11)
and Long Edge (12) of carrier basket, insert the
Screw (9) with Washer (10) from both sides,
fasten Screw (9) into the Rivet Nut mounted on
the Support Plate (11). Repeat this step to
connect six Support Plate (11) with two Long
Edge (12) of Carrier Basket.
Long Edge (12)
Washer (10)
Step 3
Insert the raised part of Short Edge (1) into the square
holes on the Long Edge (12) of carrier basket, secure the
Short Screw (6) and Long Screw (7) with Nut (8).
Long Edge (12)
Short Screw (6)
Long Screw (7)
Washer (4)
Nut (5)
Screw (9)
Support Plate (11)
Short Edge (1)
Nut (8)
Step 4
Using the Bolt (18) and Nut (17), fasten the Brace (16)
and Hitch Tube (20).
Brace (16)
Bolt (18)
Hitch Tube (20)
Step 5
Attach carrier basket to hitch tube. Find the two attach-
ment holes on both the "front" and "back" edge of carrier
basket. Inset the Screw (13) with Washer (14) from the
top, through the Long Edge (12) and Brace (16). Secure
the bolt with Washer (14) and Nylon Nut (15), Repeat
this at the other 3 attachment points to secure the Carrier
onto end of Hitch Tube (20).
Screw (13)
Washer (14)
Nylon Nut (15)
Washer (14)
With all components now assembled, make sure all
hardware is securely tightened.
WARNING
The Cargo Carrier must be attached to a 2" x
2" Class III or Class IV hitch receiver.
WARNING
Do not exceed the 500 Lbs. maximum
weight capacity. Weight inside the Cargo
Carrier should be evenly distributed, with
heavier items positioned towards the cen-
ter of the Cargo Carrier.
Nut (17)