DigiTech XP100 Owner's Manual page 3

mode. The beauty of the the User mode is, that the XP-100 will give you the opportunity to store up to 6
of your favorite factory programs in the same area. This will save you the toe-tap dancing ritual of
accessing programs. This button is also used to calibrate the noise gate threshold of the XP-100. To put
the XP-100 in User mode, simply press the <Mode/(Hold) Program> button.
To store a Factory program as a User program, the procedure is as follows:
First, select the Program to be stored. Press and hold the <MODE/(HOLD)PROGRAM> button.
The display will flash:
user location. Now just press the <MODE/(HOLD)PROGRAM> button to save. The display will
read: SA to confirm, then return to Program mode.
To calibrate the Noise Gate threshold, press and hold the <GATE CALIBRATE> button while
applying power to the XP-100 until the display reads th . Use the expression pedal to set the
threshold. Rocking the pedal forward=higher threshold, pedal back=lower threshold. When the
pedal is brought all of the way back, the gate is bypassed. The display will show the threshold
range from 0-99. When the threshold is set to the desired value, press the <MODE/(HOLD)PRO-
GRAM> button to save. The display will read: SA to confirm, then return to Program mode.
12. AC Line Input - Connect the power adpater here. Use only the enclosed PS 750 power supply.
Tuner Mode
To access the Tuner mode, press and hold the <BYPASS/(Hold)TUNER> footswitch until tu appears in the
T
display. he currently played note is displayed in the left character of the status display window, while the
intonation is displayed in the RIGHT character of the window.
When the input note is in tune, the display will read:
When the note is flat, the intonation character will rotate counter clockwise as shown:
When the note is sharp, the intonation character will rotate clockwise as shown:
The faster the character spins (either clockwise or counter clockwise), the more out of tune the note is.
Bypass Mode
To place the XP-100 in bypass mode, press the <BYPASS/(Hold)TUNER> footswitch once.
When the XP is in Bypass mode, the Expression pedal is inactive, but programs can still be selected using
the <UP/(Hold)DOWN> footswitch while the unit is in bypass. The new program is loaded once Bypass
mode is exited. When the XP is in bypass mode, the display will read:
U1 . From here, use the <UP/(Hold)DOWN> footswitch to select which